Abstract:Absorptive separation for resource utilization by selective SO2 removal from flue gas is a potential method applicable in practice. A flue gas desulfurization process for SO2 utilization by selective absorption in a lab-scale absorption tower at atmospheric pressure using N-formylmorpholine (NFM) as the absorbent is developed to capture and concentrate the SO2 from flue gas, in which the CO2 content is several orders higher than that of SO2. The investigation of the effects of different operating conditions on the SO2 removal efficiency shows that the SO2 removal efficiency can be obviously enhanced by increasing NFM concentration, or decreasing the absorption temperature, the superficial gas velocity, the gas-liquid ratio, or the SO2 concentration in absorption solution. Under the optimum operating conditions (covering a temperature of 40 degrees C, a superficial gas velocity of <0.0165 m/s, a gas-liquid ratio of 200-250, a SO2 concentration in lean NFM solution of 0-10 mg/L, and a NFM concentration of 3 mol/L), the SO2 removal rate reaches over 99.5% while the absorption of CO2 is negligible. Similarly, the SO2 removal rate is as high as 99.5% obtained in consecutive absorption-desorption cycles. Desorption experiment results indicate that the absorption of sulfur dioxide is completely reversible and the release of SO(2 )from NFM is very easy and rapid at 104 degrees C. The absorption simulation result for desulfurization of flue gas vented from the industrial catalytic cracking regenerator shows that 98.0% of SO2 can be absorbed in the absorber and most of them are released in the desorber. The experimental and simulated results show that the desulfurization ability and regenerability of NFM solution is encouraging for the development of FGD process to capture the SO2 from flue gas.

INTERACTION BETWEEN SO2 FROM FLUE GAS AND SORBENT PARTICLES IN DRY FGD PROCESSES

Reaction behavior of SO2 in the sintering process with flue gas recirculation

Research Progress of FGD Technology by Limestone Injection in Pulverized-Coal Fired Boilers

Utilization of Desulfurization Gypsum to Producing SO2 and Cao in Multi-Stage Fluidized Bed

APPLICATION FUTURE OF DRY AND SEMI-DRY FLUE GAS DESULPHURIZATION IN COAL-FIRED POWER PLANTS

Study on a Novel Semidry Flue Gas Desulfurization with Multifluid Alkaline Spray Generator

Study On So2 Removal During Pulverized-Coal Combustion

Recent Advances in Flue Gas Desulphurization in Coal-Fired Power Plant

Experimental Study on SO2 Recovery Using a Sodium–zinc Sorbent Based Flue Gas Desulfurization Technology

SOx Removal and Emission Characteristics of WFGD System Applied in Ultra-Low Emission Coal-Fired Power Plants

Production of SO2 Gas: New and Efficient Utilization of Flue Gas Desulfurization Gypsum and Pyrite Resources

Simultaneous Removal of So2 and Small Particles in A Multistage Spouted Fluidized Tower

Research progress of SO2 and NOx synergistic removal by calcium-based desulfurization

Study on desulfurization reaction characteristic of calcium-based sorbents

Sulfur Removal at High Temperature During Coal Combustion in Furnaces: A Review

Study on Flue Gas Desulfurization Process with Selective SO2 Removal by N-formylmorpholine

STUDY ON TWO-STAGE DESULFURIZATION TECHNOLOGY WITH PREMIXED AND INJECTED SORBENTS IN COAL-FIRED BOILERS

CHARACTERISTICS OF SULFURDIOXIDE ABSORPFION IN MULTI-COMPONENT SUSPENSIONS

Study on SO2 removal of calcium sorbent mixed with pulverized coal ash

Mechanism of Dry Fgd Process and Characters of Circulating Particles

Experimental study of steam reactivation of calcium-based sorbent for dry FGD process