Abstract:SO2 emissions from coal-fired boilers are air pollutants and a source of acid rain, causing extensive environmental pollution. Limestone (CaCO3) is a Ca-based sorbent which is injected into circulating fluidized bed (CFB) boilers, where it combines with SO2 to produce calcium sulfate (CaSO4). As a result, SO2 emissions from a power plant are reduced. In this study, CaCO3 addition was proposed and the desulfurization efficiency improved. The direct desulfurization reaction is dominant in a commercial CFB boiler due to the high CO2 partial pressure, but CaO is formed at a fast reaction rate by calcination in the high temperature or in the low CO2 partial pressure region. When CaO remains in the loop seal, it is exposed to a high CO2 partial pressure condition moving through the recirculation section for an extended period and re-injected into the furnace as recarbonated CaCO3. To analyze the direct desulfurization reaction kinetics, a shrink core model in which the reaction proceeds inside the particle was adopted. Surface observations through FE-SEM of CaSO4 produced by the 180 minute long desulfurization experiment using TGA suggest that the CaSO4 crystal growth rate increased after the pre-treatment (recarbonation) of limestone. Recarbonation lowered the limestone crystallinity, causing a faster reaction. The CaCO3 recarbonation increased the Ca utilization by more than 20% when the direct desulfurization reaction occurred. The TGA experiments show that recarbonation contributes to CaSO4 conversion. Increasing the desulfurization efficiency using recarbonation can reduce the fixed investment and operating costs of oxy-fuel CFB plants because only desulfurization in the furnace is able to meet SO2 emission regulations or lower the flue gas desulfurization (FGD) dependence. Accordingly, the desulfurization conversions of recarbonated CaCO3 and limestone were compared in this study. Morphological changes in the limestone were also evaluated using XRD, FE-SEM, and other analysis methods.

Sorbent performance under FBC conditions-a thermochemical analysis

Sorbent Performance under FBC Conditions -- A Thermochemical Analysis

High-Temperature Sulfur Removal Under Fluidized-Bed Combustion Conditions - A Chemical Interpretation

A comparative evaluation of recarbonated CaCO3 derived from limestone under oxy-fuel circulating fluidized bed conditions

So2 Capture and Attrition Characteristics of A Cao/Bio-Based Sorbent

Experimental study on the effect of limestone on SO2 and NO emission characteristics during coal/coke combustion

Desulfurization Characteristic of Calcium-Based Sorbent During Activation Process.

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Limestone Effects on NOx Formation & Emission in CFB Combustors

Dry Desulfurization in a Circulating Fluidized Bed (CFB) with Chain Reactions at Moderate Temperatures

Staged Desulphurization by Direct Sorbent Injection in Pulverized-Coal Boilers

Applications of ultrafine limestone sorbents for the desulfurization process in CFB boilers.

Numerical and Experimental Investigation of the Effects of Impinging Streams to Enhance Ca-based Sorbent Capture of SO2

Experimental Study on in Situ Preparation of Supported Sorbent for Moderate Temperature CFB-FGD

Novel Dry-Desulfurization Process Using Ca(OH)2/Fly Ash Sorbent in a Circulating Fluidized Bed

A simplified technique for measurement of sorbent reactivity for use in circulating fluidized bed combustors

E211 STAGED SORBENT INJECTION UNDER AIR-STAGED COMBUSTION CONDITIONS FOR SO_2 REDUCTION IN A PULVERIZED COAL FIRED BOILER

Limestone Attrition and Product Layer Development During Fluidized Bed Sulfation

Experiments on H2S sorption by limestone in a fluidized bed gasifier

Kinetic model for desulfurization at medium temperature using hydrated absorbent

CO2 Capture from Flue Gases Using Three Ca-Based Sorbents in a Fluidized Bed Reactor