Abstract:The diamond-like carbon films (DLC) coated on medical titanium alloy suffer from the problem of insufficient coatings adhesion due to thermal expansion mismatch, different wetting properties at the film/substrate interface. In order to enhance DLC coatings adhesion, the titanium alloy substrate surface was pretreated by laser texturing and carburizing with different texture densities and different laser carburizing powers. The adhesion and tribological properties of the laser textured (LTC), laser carburized (LCC), and hybrid laser textured and carburized (LTCC) DLC coatings were evaluated by scratch test, indentation test and wear test, compared with the only polished DLC coatings (PC). The results showed that the bonding strength of LTC, LCC and LTCC samples was about 1.52, 1.62 and 2.14 times higher than that of PC samples, and the best tribological properties were obtained for LTCC samples. Meanwhile, the density of micro-dimples and the power of laser carburizing significantly affect the adhesion and tribological properties. Among the dent densities studied, textured samples with a density of 30 % showed the lowest mean friction coefficient and wear rate. The critical force of the carburized DLC coatings was first rising and then falling as the laser carburizing power increased, and the bond strength of the film base reached the maximum at a carburizing power of 10 W. The texturing treatment results in an improvement of the specific surface area of the substrate and the laser carburizing treatment results in an increase of the coating nucleation density and decrease of coatings graphitization degree, both improving the coatings adhesion and triboligical behavior.

Residual Stresses And Debonding Of Diamond Films On Titanium Alloy Substrates

Impact of temperature on residual stress and bonding in diamond-like carbon film: A molecular dynamics study under various deposition conditions

Adhesion Evaluation of CVD Diamond Films and Metal Reinforced Composite Diamond Films

In-Situ Tensile Deformation Behavior Of As-Built Laser Direct Metal Deposited Ti-6al-4v Alloy At 200 Degrees C

Electron-Beam Defined Delamination and Ablation of Carbon-Diamond Thin-Films on Silicon

Tribological Properties Of Diamond-Like Carbon-Films Deposited On Silicon Using Rf Plasma-Enhanced Cvd

Fracture Strength and Toughness of Chemical-Vapor-deposited Polycrystalline Diamond Films

Tribological Properties of Graded Diamond-Like Carbon Films on Ti Ion-Implanted Aluminum Substrate

Study On The Properties Of Diamond Films On Cemented Carbide Substrates By Surface Implantation Pretreatment Process

Diamond-Like Carbon Thin Films Deposited On Ti6al4v Alloy Surface By Plasma Gun At Atmospheric Pressure

Effect of Stress State of Different Tin Films on Their Tribological Behavior

Study of the Stress Observed in Diamond Films on Carbon-Implanted Alumina Surfaces

Experimental and Numerical Evaluations of Adhesion Strength and Stress in Tin Films Deposited on Ti-Implanted Aluminum

Study on the substrate surface micro-texturing/carburizing regulating the film-substrate adhesion and wear behavior of DLC coatings

Effect of Temperature on Residual Stress and Mechanical Properties of Ti Films Prepared by Both Ion Implantation and Ion Beam Assisted Deposition

Effect of stress state in different TiN-films on their tribological performances

Effect of Impact Angle and Substrate Roughness on Growth of Diamond-Like Carbon Films

Ex Situ Residual Stress Analysis of Chemical Vapor Deposited Diamond Coated Cutting Tools by Synchrotron X‐Ray Diffraction in Transmission Geometry

Existence state of Ti in diamond-like carbon coatings and its effects on hybrid structure and residual stress: Molecular dynamics simulations

A study of the stress and resistivity of Al/Ti films deposited by an ion beam assisted process for surface acoustic wave devices applications

Adhesion, biological corrosion resistance and biotribological properties of carbon films deposited on MAO coated Ti substrates