Abstract:In the present work, the tribological mechanism of diamond-like carbon (DLC) films was investigated. DLC films were coated on metallic substrates (M50 steel, Ti-6Al-4V alloy and AISI 440C steel) by methane ion-beam deposition. Pin-on-disc experiments showed that the DLC films possess excellent wear resistance and exhibit low values of friction coefficient (ƒ < 0.1). The frictional response was characterized by an initial break-in period that was followed by an intermediate constant ƒ stage. The presence of a carbon transfer layer was observed on the wear scars of ball surfaces. Transmission electron microscopy and electron diffraction from the transfer layer showed that it contained a fine distribution of graphite nanoparticles (less than 5 nm) in a distorted diamond-like structure. Laser Raman spectra taken from the wear track region also revealed evidence of graphitization. In light of the present observations, the intermediate friction stage was mainly attributed to transfer layer formation. During long-duration wear experiments, a further reduction in ƒ was observed that finally reached steady state low friction (ƒ = 0.05–0.07) and an ultralow wear rate (about 1.6 × 10−9mm3 m−1 N−1). Steady state was related to the complete transformation of diamond-like to graphite-like carbon under thermal and strain effects from the repeated friction through a precursor stage involving hydrogen evolution and sp3 structure destabilization. The ultra-low wear rates were correlated to easy shear of low-strength atomic carbon interlayers in the graphitic structure.

Diamond-Like Carbon Thin Films Deposited On Ti6al4v Alloy Surface By Plasma Gun At Atmospheric Pressure

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Deposition of nano-diamond-like carbon films by an atmospheric pressure plasma gun and diagnostic by optical emission spectrum on the process

Preparation and Tribological Properties of DLC/Ti Film by Pulsed Laser Arc Deposition

Friction and wear study of diamond-like carbon gradient coatings on Ti6Al4V substrate prepared by plasma source ion implant-ion beam enhanced deposition

Structural Characters and Tribological Properties of Diamondlike Carbon Films

Investigating the microstructure and mechanical behaviors of DLC films on AISI52100 bearing steel surface fabricated by plasma immersion ion implantation and deposition

Tribological Properties of Diamond– Like Carbon Films Deposited by PECVD

Investigation of Diamond-like Carbon Films Synthesized by Plasma Gun at an Atmospheric Pressure

Diamond-like Carbon Film Synthesized by Ion Beam Assisted Deposition and Its Tribological Properties

Tribological Properties of Diamond-Like Carbon Films Deposited by Pulsed Laser Arc Deposition

Tribological Performance of Ultrathin Diamond-Like Carbon Films Prepared by Plasma-Based Ion Implantation

Diamond-like carbon films synthesized on bearing steel surface by plasma immersion ion implantation and deposition

Tribological Properties of Graded Diamond-Like Carbon Films on Ti Ion-Implanted Aluminum Substrate

Microstructure and properties of diamond-like carbon deposited at room temperature

Synthesis and Tribological Properties of Diamond-Like Carbon Films by Electrochemical Anode Deposition

Structural, Mechanical and Tribological Behavior of Different DLC Films Deposited on Plasma Nitrided CF170 Steel

Synthesis And Tribological Properties Of Diamond-Like Carbon Films Prepared On Stainless Steel By Rfpecvd Process

On the adhesion of diamond‐like carbon coatings deposited by low‐pressure plasma on 316L stainless steel

A study of the wear mechanism of diamond-like carbon films