Abstract:A series of tungsten-gradually doped diamond-like carbon (DLC) films with functionally graded interlayer were prepared using a hybrid technique of vacuum cathodic arc/magnetron sputtering/ion beam deposition. With ‘compositionally graded coating’ concept, the deposition of wear-resistant carbon-based films with excellent adhesion to metallic substrate was realized. In the films, a functionally graded interlayer with layer sequence of Cr/CrN/CrNC/CrC/WC was first deposited onto the substrate, and then, a DLC layer doped with gradually decreasing content of W was coated on. The W concentration gradient along depth of the film was tailored by adjusting the W target current and deposition time. The characterized results indicate that the microstructural, mechanical and tribological properties of these films show a significant dependence on the W concentration gradient. A high fraction of W atom in carbon matrix can promote the formation of sp2 sites and WC1−x nanoparticles. Applying this coating concept, strongly adherent carbon films with critical load exceeding 100N in scratch test were obtained, and no fractures or delaminations were observed at the end of the scratched trace. The hardness was found to vary from 13.28 to 32.13GPa with increasing W concentration. These films also presented excellent tribological properties, especially significantly low wear rate under dry sliding condition against Si3N4 ball. The optimum wear performance with friction coefficient of 0.19 and wear rate of 8.36×10−7 mm3/Nm was achieved for the tungsten-gradually doped DLC film with a graded W concentration ranging from 52.5% to 17.8%. This compositionally graded coating system might be a potentially promising candidate for wear-resistant carbon-based films in the demanding tribological applications.

Diamond-like Carbon Film Synthesized by Ion Beam Assisted Deposition and Its Tribological Properties

Studies of Diamond-Like Carbon Films Prepared by Ion Beam-Assisted Deposition

Tribological Properties of Diamond-Like Carbon Films Deposited by Vacuum Arc

Ion Beam Assisted Deposition of Diamond-Like Carbon Onto Steel Materials: Preparation and Advantages

Structural Characters and Tribological Properties of Diamondlike Carbon Films

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Diamond-Like Carbon Thin Films Deposited On Ti6al4v Alloy Surface By Plasma Gun At Atmospheric Pressure

Tribological Properties of Diamond-Like Carbon Films Deposited by Pulsed Laser Arc Deposition

Bonding Structure and Tribological Properties of Dlc Films Synthesized by Dual-Ion Beam Sputtering

Mechanical and tribological properties of non-hydrogenated DLC films synthesized by IBAD

Structural Characterization And Properties Enhancement Of Diamond-Like Carbon-Films Synthesized Under Low-Energy Ne+ Bombardment

Excellent Adhered Thick Diamond-Like Carbon Coatings by Optimizing Hetero-Interfaces with Sequential Highly Energetic Cr and C Ion Treatment

Preparation and Tribological Properties of DLC/Ti Film by Pulsed Laser Arc Deposition

A study of the wear mechanism of diamond-like carbon films

Mechanical and Tribological Properties of Diamond-Like Carbon Films Deposited by Electron Cyclotron Resonance Microwave Plasma Chemical Vapor Deposition

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Enhancement of tribological properties by dynamic mixing of diamond-like carbon/Mo films on steel

Effect of Ion Bombardment Energy on the Properties of Diamond-like Carbon Film

Electrodeposition, microstructure, friction and electrochemical behavior of diamond-like carbon (DLC) films with Ni/Cu interlayer

Microstructural, Mechanical and Tribological Properties of Tungsten-Gradually Doped Diamond-Like Carbon Films with Functionally Graded Interlayers

Tribological Behaviors of Diamond-Like Carbon Coatings on Plasma Nitrided Steel Using Three BN-containing Lubricants