Abstract:The work aims to study effects of sliding speed, normal load and heating temperature on friction and wear properties of Ni-P/Ti/DLC multilayer films. Ni-P layer was plated on die steel substrates by adopting electroless nickel-phosphate plating process, and Ti transition layer and DLC protective layer were deposited by adopting filtered cathodic vacuum arc tech·60· 表面技术 2018 年 7 月 nology individually. Friction and wear properties of the multilayer films were evaluated in friction and wear experiments. Hardness, elastic modulus and composition of the multilayer films at different heating temperature were characterized based upon nanoindentation test and Raman spectrum detection. Wear track morphology and cross-sectional profile of the multilayer films were also analyzed with scanning electron microscope (SEM) and surface profile instrument. As the sliding speed increased, friction coefficient of the multilayer films decreased, and wear rate and volume first reduced and then increased. Friction coefficient of multilayer films changed slightly at different normal loads, and wear rate and volume increased as normal load increased. As the heating temperature increased, the friction coefficient of multilayer films decreased, and wear rate and volume first increased and then decreased. In addition, at higher heating temperature, graphite phase gradually increased on DLC layer of the multilayer films, hardness and elastic modulus tended to first increase and then decrease. At higher slide speed, graphitization trend of the DLC layer intensifies, friction coefficient changes greatly, width and depth of wear tracks increase greatly, and wear is worse. Soft Ti metal layer and hard DLC layer in multilayer films can effectively improve friction and wear properties at high load. As heating temperature increases, graphite phase gradually increases in DLC layer, and transfer film is easier to be generated in friction process.

Effect of Stress State of Different Tin Films on Their Tribological Behavior

Effect of stress state in different TiN-films on their tribological performances

PREPARATION AND TRIBOLOGICAL PROPERTIES OF TiO2-ZrO2 THIN FILMS

Friction and Wear Properties of Ni-P/Ti/DLC Multilayer Films

A Comparative-Study on Microstructure and Tribological Properties of Si3n4 and Tin Thin-Films Produced by Ibed Method

Influence of Interfacial Tribo-Chemical and Mechanical Effect on Tribological Behaviors of TiN Film in Different Environments

Residual Stresses And Debonding Of Diamond Films On Titanium Alloy Substrates

The Tribological Behaviors of Three Films Coated on Biomedical Titanium Alloy by Chemical Vapor Deposition

High Temperature Sliding Wear Behaviors of Ion Plating Tin Composite Coating with Ion Nitriding As Interlayer on Hot Work Die Steel

Experimental and Numerical Evaluations of Adhesion Strength and Stress in Tin Films Deposited on Ti-Implanted Aluminum

Film thickness effect on texture and residual stress sign transition in sputtered TiN thin films

Investigation of the characteristics of TiN-coating film deposited by arc ion plating method and the feasibility of measuring residual stress according to heat treatment

Tribological Performances of TiAlN Film on TC4 Alloy Surface Prepared by Two Kinds of Arc Target

Effect of Triangular Texture on the Tribological Performance of Die Steel with Tin Coatings under Lubricated Sliding Condition

Tribological behaviour of TiAlN and AlCrN coatings on stainless steel

Tribological Properties of Craln and Tin Coatings Tested in Nano- and Micro-Scale Laboratory Wear Tests

Effect of depositing parameters on microstructures and properties of multi arc ion plating ZrTiN films

The growth of anti-friction and wear-resistance TiO2 nanotube arrays driven by residual stress

Stress-induced alternating microstructures of titanium/steel bonding interface

Effect of Stellite12 and NiCrBSi HVOF coatings on the tribological behavior of CrN PVD film

Microstructure and Tribological Behavior of Pulsed Laser Deposited A-Cnx Films