Abstract:The variations of coarse intermetallic particles in hot-extruded 7055 aluminum alloys with 0.041 wt% Fe and 0.024 wt% Si increasing to 0.272 wt% Fe and 0.134 wt% Si were investigated. The particle stimulated nucleation (PSN) behaviors for different kind of coarse particles were detailly analyzed by EBSD. Moreover, the effect of PSN responding to Fe and Si contents on recrystallization and tensile properties of 7055 alloys was evaluated. With increasing Fe and Si contents, the size and number density of coarse η/S particles are reduced, while the number densities of coarse Al7Cu2Fe and Mg2Si particles are both increased and the coarse Al7Cu2Fe particles transform from rod-like to irregular. More PSN recrystallized grains with predominant orientations deviated from the extruded fiber textures are stimulated by the irregular Al7Cu2Fe and Mg2Si particles, because a higher degree of local non-uniform deformation is produced. The rod-like Al7Cu2Fe particles cause the greatest degree of local non-uniform deformation owing to the largest aspect ratio, but the shape also restricts the area of particle deformation zone (PDZ) resulting in fewer PSN recrystallized grains. The irregular η/S particles give rise to the lowest degree of local non-uniform deformation and fewest PSN recrystallized grains with the major orientations close to the extruded fiber textures. Consequently, despite the number and size of coarse η/S particles are reduced, the proportion of high angle grain boundaries (HAGBs) is increased and the extruded fiber textures are weakened with Fe and Si contents increasing, because of the increased Al7Cu2Fe and Mg2Si particles. The strength is slightly declined by the weakened <111>//ED (extrusion direction) fiber texture, while the elongation is reduced for a larger number of coarse particles and more HAGBs with higher Fe and Si contents.

The coarsening of silicon particles in a submicron-grained layer-deposited Al-12wt% Si alloy

Coarsening Characteristic of Si Particles in Powders of Rapidly Solidified Al-Si Alloy

Growth Mechanism of Eutectic Si in Super-Gravity Solidified Al-Si Alloy During Annealing

Microstructure Evolution of A Fine Grain Al-50wt%Si Alloy Fabricated by High Energy Milling

Characterization of the Interface Region During the Agglomeration of Silicon Nanocrystals in Silicon Dioxide

Fabrication of fine grain SiAl alloy and its uniform thermal conductivity

Uncovering the role of nanoscale Si particles on the thermal stability of a lamellar-nanostructured Al–1%Si alloy

Softening kinetics and mechanism during the annealing of an Al-Si alloy produced by laser powder bed fusion

Formation mechanism and conditions of fine primary silicon being uniformly distributed on single αAl matrix in Al-Si alloys

Grain Growth and Recrystallization Behaviors of an Ultrafine Grained Al-0.6 Wt%mg-0.4 Wt%si-5Vol.%sic Nanocomposite During Heat Treatment and Extrusion

Coarsening behavior of (Ni, Co)2Si particles in Cu–Ni–Co–Si alloy during aging treatment

Synergistic Effects of Γ-Al2o3 Nanoparticles and Fast Cooling on the Microstructural Evolution and Mechanical Properties of Al-20Si Alloys

Relationship of particle stimulated nucleation, recrystallization and mechanical properties responding to Fe and Si contents in hot-extruded 7055 aluminum alloys

Nanoparticle-Induced Nucleation of Eutectic Silicon in Hypoeutectic Al-Si Alloy

Grain refinement mechanism of soft-magnetic alloys with nanocrystals embedded in amorphous matrix

Heterogenous Grain Nucleation in Al-Si Alloys: Types of Nucleant Inoculation

Precipitation and Crystallization of Nanometer Si Clusters in Annealed Si-Rich Sio2 Films

Origin of the Separated Α-Al Nanocrystallization with Si Added to Al86Ni9La5 Amorphous Alloy

Temperature-dependent Formation of Gradient Structures with Anomalous Hardening in an Al–Si Alloy

Influence of Si on grain refinement efficiency of Al-Ti-B and Al-Ti-C master alloys

The Crystallization of Cr–Si–Ni–Al Amorphous Films—nucleation and Growth of Intermetallic Phase Cr(Al,Si)2