Abstract:Surface mechanical attrition treatment (SMAT) was employed to produce gradient structures in AZ31B Mg alloy samples with two different initial textures. The structure of both samples can be regarded as an integration of two main layers: the severely deformed layer exhibited dramatic grain refinement to nano- and submicron-scale with weakened and randomized textures; the less deformed layer exhibited the inherited coarse grains with increased dislocation density, possessing the similar texture with the sample prior to SMAT. All the samples containing different layer constituents cut from the SMAT alloys showed remarkable increase of strength compared to the original Mg alloy. However, the two integral SMAT samples with different initial textures exhibited marked difference in uniform elongation (UE) during tension. That was attributed to the different strain hardening behaviors influenced by the deformation coordination and strain partitioning between layers with different orientation relationships. The 0° oriented SMAT sample showed no macroscopic strain transfer or slip transmission across layers, which was hard to cause dislocation accumulation throughout the whole thickness of the layered sample. That resulted in a limited strain hardening and UE. However, the favored orientation relationship between layers of the 45° oriented SMAT sample facilitated the strain transfer and slip continuity across the layers. That generated a dynamically migrating interface during tension, which allowed the dislocations accumulating over the whole sample volume. This caused a pronounced strain hardening and sustained UE to an appreciable value.

Temperature-dependent Formation of Gradient Structures with Anomalous Hardening in an Al–Si Alloy

Growth Mechanism of Eutectic Si in Super-Gravity Solidified Al-Si Alloy During Annealing

Investigation on the Grain Structure Evolution and Abnormal Stress Increase of Al–Mg–Si Alloy During Hot Deformation

Strain Hardening and Tensile Behaviors of Gradient Structure Mg Alloys with Different Orientation Relationships

Temperature-Dependent Mechanical Behaviors and Deformation Mechanisms in a Si-Added Medium-Entropy Superalloy with L12 Precipitation

Atomic-scale Insights into the Effect of Layer Thickness Ratio on the Tensile Properties of Heterostructured Nano-Aluminum

Unprecedented Age-Hardening and Its Structural Requirement in a Severely Deformed Al-Cu-Mg Alloy

The Evolution of Unidirectional Solidification Microstructure of the Al-In Monotectic Alloys in High Temperature Gradient

Evolution of Grain Structure and Dynamic Precipitation during Hot Deformation in a Medium-Strength Al-Zn-Mg-Er-Zr Aluminum Alloy

Tensile behaviors and hetero-deformation-induced hardening mechanisms in medium entropy alloys with dual gradients of grain size and coherent nanoprecipitate

Characterization of Hot Deformation Behavior and Constitutive Modeling of Al–Mg–Si–Mn–Cr Alloy

Hot Deformation Behavior of a Co-Spray-Formed Al-Si/7075 Bimetallic Gradient Alloy

Characterization of Hot Deformation Behavior and Processing Maps of Homogenized Al-Mg-Si-Sc-Zr Alloys

Atomic faulting induced exceptional cryogenic strain hardening in gradient cell–structured alloy

Tensile Flow and Work Hardening Behaviors of Ultrafine-Grained Mg-3al-Zn Alloy at Elevated Temperatures

Hot Deformation Behavior and Microstructure Evolution of High-Strength Al-Zn-Mg-Cu Alloy

Designing structures with combined gradients of grain size and precipitation in high entropy alloys for simultaneous improvement of strength and ductility

Strain hardening behavior and microstructure evolution of gradient-structured Cu-Al alloys with low stack fault energy

Extreme shear-deformation-induced modification of defect structures and hierarchical microstructure in an Al–Si alloy

Enhancing the ductility in the age-hardened aluminum alloy using a gradient nanostructured structure

Hot Deformation Behavior and Microstructural Evolution of a New Type of 7xxx Al Alloy