Abstract:In this research, a high-efficiency design method of the capacitive MEMS accelerometer is proposed. As the MEMS accelerometer has high precision and a compact structure, much research has been carried out, which mainly focused on the structural design and materials selection. To overcome the inconvenience and inaccuracy of the traditional design method, an orthogonal design and the particle swarm optimization (PSO) algorithm are introduced to improve the design efficiency. The whole process includes a finite element method (FEM) simulation, high-efficiency design, and verification. Through the theoretical analysis, the working mechanism of capacitive MEMS accelerometer is clear. Based on the comparison among the sweep calculation results of these parameters in the FEM software, four representative structural parameters are selected for further study, and they are le, nf, lf and wPM, respectively. le and lf are the length of the sensing electrode and fixed electrode on the right. nf is the number of electrode pairs, and wPM is the width of the mass block. Then, in order to reduce computation, an orthogonal design is adopted and finally, 81 experimental groups are produced. Sensitivity SV and mass Ma are defined as evaluation parameters, and structural parameters of experimental groups are imported into the FEM software to obtain the corresponding calculation results. These simulation data are imported into neural networks with the PSO algorithm. For a comprehensively accurate examination, three cases are used to verify our design method, and every case endows the performance parameters with different weights and expected values. The corresponding structural parameters of each case are given out after 24 iterations. Finally, the maximum calculation errors of SV and Ma are 1.2941% and 0.1335%, respectively, proving the feasibility of the high-efficiency design method.

Study on the Testing Method for the Quality Factor of Capacitive Accelerometer Based on Step Response

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Noise Behaviors of a Closed-Loop Micro-Electromechanical System Capacitive Accelerometer

Design of Force-Balance Capacitive Accelerometer

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

Thermal Stress Analysis of MEMS Accelerometer Based on Finite Element Method

Modeling and Noise Analysis of a Fence Structure Micromachined Capacitive Accelerometer System

Study of a Novel Micromachined Capacitive Accelerometer

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

Application of the Quartz-flexure Accelerometer to the Development of Ultra-low Frequency Vibration National Primary Standard Device

Quality Factor Estimates of Resonant Beams with Nonlinear Vibrations

Influence of Feedback Compensation on Dynamic Property for High-Q Capacitive Accelerometers

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

Measuring Principle and Dynamic Characteristics Design for An Electro-Statically Suspended Accelerometer with Differential-Capacitance

Design, Fabrication and Test of a Low Range Capacitive Accelerometer With Anti-Overload Characteristics

A micro resonant pressure sensor with adjustable quality factor

Analysis and Optimization on Dynamic Characteristics and Important Parameters of Force Feedback Accelerometer

Electrometric Method for Measuring the Mechanical Parameters of a Comb-Finger Micro-Mechanical Accelerometer

A Novel Self-Test Structure for Time-Divided Closed-Loop MEMS Capacitive Accelerometer

Design and realization of testing instrument applied to MEMS accelerometer sensor

Experimental analysis of MEMS capacitive accelerometer's shock resistibility