Abstract:To improve the mechanical and tribological properties of hydrogen-containing diamond-like (H-DLC) films under typical space environment—atomic oxygen (AO) erosion, H-DLC films with multilayer structure of Cr-doped and B-doped were prepared on the surface of GCr15 steel by non-equilibrium magnetron sputtering technique. The changes of mechanical properties such as hardness, elastic modulus and residual stresses of the three DLC films, H-DLC, Cr-H-DLC and B-H-DLC, before and after AO erosion were investigated contrastively. It was found that AO erosion reduced the sp3 hybrid bonds content in the three DLC films, leading to a decrease in film hardness and elastic modulus, and it was also found that the residual stresses in the films were all increased after AO erosion. Compared with the friction test carried out only in a vacuum condition without AO erosion, the coefficient of friction (COF) of the films after AO erosion changed slightly, but the wear life showed a notably decrease and a large number of pear grooves appeared in the wear scars. Although wear life of the three DLC films decreased after AO erosion, the decrease of Cr-H-DLC film was much smaller than the remaining two. According to the Raman spectra results, it was found that the ID/IG values at the wear scars of H-DLC film became larger after AO erosion, and the ID/IG values at the wear scars of Cr-H-DLC and B-H-DLC films did not change much, indicating that the AO erosion induced more sp2 CO bonds with high binding energy in the H-DLC films, which, together with the degradation of the films' mechanical properties, led to the decrease in the wear life of the H-DLC films. The doping of Cr element produced less CO bonds and thus the decrease of film's wear life was smaller. The effect of doping with B elements on film's wear life was not significantly, but achieving the lowest COF.

Erosion resistance of polycrystalline diamond films to atomic oxygen

Reaction Of Diamond Thin Films With Atomic Oxygen Simulated As Low-Earth-Orbit Environment

Fracture Strength and Toughness of Chemical-Vapor-deposited Polycrystalline Diamond Films

Effect of atomic oxygen erosion on mechanical and tribological properties of Cr and B doped hydrogen-containing diamond-like carbon films

Single-crystal and polycrystalline diamond erosion studies in Pilot-PSI

Erosion of Tungsten-Doped Amorphous Carbon Films in Oxygen Plasma

XPS analysis of molecular contamination and sp2 amorphous carbon on oxidized (100) diamond

Erosion Behavior of C/SiC Composites in Atomic Oxygen

Tribological Properties Of Diamond-Like Carbon-Films Deposited On Silicon Using Rf Plasma-Enhanced Cvd

Effects of Oxidation on the Tribological Properties of Diamond Sliding Against Silica. Insights from Ab initio Molecular Dynamics

Effect of oxygen/argon ratio on microstructure, compositon and optical properties of erbium oxide anti-reflection films on CVD diamond

Deuterium-oxygen exchange on diamond (100)—a study by ERDA, RBS and TOF-SIMS

Silicon Dioxide Deposition by Atmospheric Pressure and Low‐Temperature CVD Using TEOS and Ozone

Effects of plasma etching treatment on the adhesion of diamond films

Atomic Oxygen Exposure Behaviors of CVD-grown Carbon Nanotube Film and Its Polymer Composite Film

Diamond-like Carbon Thin Films Prepared by ECR Argon Plasma Assisted Pulsed Laser Deposition

Research on Atomic Oxygen Erosion Influence of Structural Damage and Tribological Properties of Mo/MoS2-Pb-PbS Thin Film

Research on Excimer Laser Induced Chemical Vapor Deposition of Diamond Films

Interactions of low energy reactive ions with surfaces. IV. Chemically bonded diamond‐like films from ion‐beam deposition

Resistance of amorphous TiAlCrZrSi/polyimide high entropy alloy films to atomic oxygen erosion

Morphologies and structures of chemical vapor deposited diamond films and film-substrate interfaces