Abstract:Single stage G-M cryocoolers (GMCs) with high cooling capacity at 20-50 K provide significant benefit for the field of high temperature superconductors, however, their working efficiency can still be improved for commercial applications. Numerical simulations can serve as a valuable guide for precise optimization of the GMC because they allow one to study its internal operating characteristics. In this research, a twodimensional, transient model of a single stage GMC with a mechanically driven displacer is built and studied using computational fluid dynamics (CFD) simulation. The modelling method has been tested and experimentally verified. It enables a view of the instantaneous non-uniform flow and temperature distributions inside the GMC. Additionally, the effects of cold end channels on the heat transfer efficiency of the cold heat exchanger while operating at a large cooling power are analyzed. The results show that during certain periods of a cycle, most of the regenerator near the cold end remains at almost the same low temperature with no temperature gradient due to the small heat capacity of the materials compared to that of the helium gas; while most of the pressure drop occurs in the region near the hot end due to the high viscosity of helium-4. For a good cooling performance at low temperatures, the cold end channels should be distributed uniformly to guarantee a uniform flow and temperature distribution in the regenerator; while for a high output cooling power at high temperatures, they should be designed to enhance the heat exchange between the gas and the cold heat exchanger as much as possible. (C) 2017 Elsevier Ltd. All rights reserved.

Comparison test of rotary valve system and solenoid valves system for a G-M type pulse tube cryocooler

Performance improvement of rotary valve for G-M type cryocooler

On-off Timing Computer Control System for Valved Refrigerator

Experimental investigation on DC flow suppression and refrigeration characteristics of a high-performance single-stage GM-type

Investigation on High-Performance Single-Stage GM-Type Pulse Tube Cooler

Improvement of a Stirling type two-stage pulse tube cryocooler

Research and Development of A Test System for the Dynamic Performance Testing of Pneumatic Solenoid Valves

Numerical Study on the Working Performance of a G-M Cryocooler with a Mechanically Driven Displacer

DC FLOW SUPPRESSION IN A SINGLE-STAGE G-M TYPE PULSE TUBE COOLER

Research on Performance Measurement System for Pneumatic Solenoid Valve

Development of a Linear Compressor for Two-Stage Pulse Tube Cryocoolers

Numerical Simulation of a GM-type Pulse Tube Cryocooler System: Part II. Rotary Valve and Cold Head

Study on a single-stage pulse tube with two-valve double-inlet configuration

Experimental Results of the Internal Process of A Double Inlet Pulse Tube Refrigerator

Advances in high frequency pulse tube cryocooler research(PartⅠ)

Refrigeration characteristic experiment in 40 K region of a two-stage pulse tube cryocooler driven by a standing wave thermoacoustic engine

Simulation and analysis of dynamic heat transfer inside a cryogenic valve under cryogenic test

Development of a two-stage pulse tube Stirling cryocooler

Comparison Test Of 2-Valved And Valveless Pulse Tube Refrigerator

Valve timing effect on the cooling performance of a 4 K pulse tube cooler

Numerical Analysis of Different Valve Effects on the Cooling Performance of A Two-Stage Gm Type Pulse Tube Cryocooler