Abstract:This article investigates the evolution of surface transverse cracks in Q345 steel during the hot‐rolling process. A slab rolling model is established based on the onsite rolling process parameters to analyze the effects of different rolling processes on the morphology and aspect ratio of surface cracks. The study summarizes the evolutionary behavior of surface transverse cracks under various rolling process parameters. This article examines the evolutionary behavior of transverse surface cracks in Q345 steel during the hot‐rolling process under various rolling conditions. "V"‐shaped cracks are prefabricated on the billet surface for laboratory hot‐rolling tests, and a corresponding rolling model is developed to validate its accuracy. The slab rolling model is established based on actual onsite rolling process parameters. The aim is to analyze the effects of different rolling conditions on the surface crack morphology and aspect ratio. The results indicate that variations in roll diameter (1400, 1300, and 1200 mm) influence crack propagation, with cracks unfolding earlier when the roll diameter is 1400 mm. At varying initial rolling temperatures (1300, 1200, and 1100 °C), cracks begin to unfold earlier at the highest temperature of 1300 °C. When examining different friction coefficients (0.4, 0.5, and 0.6), cracks unfold earlier at the highest coefficient of 0.6. Similarly, at different rolling speeds (3, 4, and 5 m s−1), cracks unfolded earlier at the highest speed of 5 m s−1. Analysis of changes in crack depth and aspect ratio during rolling shows that the initial few passes have a greater influence on crack depth and unfolding. In the later stages of rolling, cracks continue to unfold, though the depth shows minimal variation, and the aspect ratio tends to approach zero.

Thermal-Mechanical Finite Element Analysis of Evolution of Surface Cracks During Slab Rolling

Evolution of Surface Crack on Slab During Rough Rolling Using Thermal-Mechanical FEM

Investigation of Closure of Internal Cracks During Rolling by FE Model Considering Crack Surface Roughness

Behaviour of longitudinal cracks on slab surfaces in V-H rolling processes

Evolution of subsurface blisters and initiation of surface crack on slab during hot rolling using FEM

Research on the Behavior of Transversal Crack in Slab V–H Rolling Process by FEM

The Cracks on Slab Corner During Hot Rolling Process

Analysis of Crack Tip Stress of Transversal Crack on Slab Corner During Vertical-Horizontal Rolling Process by FEM

Roller's Deformation Analysis under Different Thermal and Mechanical Conditions

Finite Element Analysis of Temper Rolling Process

Research on Behavior of Slab Surface Defects in Forward Slip Zone during V-H Rolling Process

Thermal-Mechanical Finite Element Analysis Of The Rolling-Sliding Contact With Inclusion

Behavior of Transversal Crack on Slab Corner During V-H Rolling Process

Evolution of Microstructure, Temperature and Stress in A High Speed Steel Work Roll During Hot Rolling: Experiment and Modelling

Friction and Slab Deformation Behaviour During Rough Rolling

Research on Crack Healing in Slab During Hot Rolling

Effect of Rolling Process Parameters on Transverse Cracks on the Surface of Q345 Steel

Occurrence of Surface Defects on Strips During Hot Rolling Process by FEM

Coupling Analysis of Multipass V-H Rolling Process by FEM

Surface rolling FE model for numerical simulation

Stress Simulation and Rolling-thoroughness Analysis of Aluminum Alloy Plate in Conversable Hot Rolling