Abstract:In response to the demand for short-range detection of anti-smoke environment interference by laser fuzes,this study proposes a smoke environment simulation of non-uniform continuous point source diffusion and investigates an experimental laboratory smoke environment using an ammonium chloride smoke agent.The particle size distribution,composition,and mass flow distribution of the smoke were studied.Based on a discrete phase model and a k-ε turbulence model,a numerical simulation was developed to model the smoke generation and diffusion processes of the smoke agent in a confined space.The temporal and spatial distribution characteristics of the smoke mass concentration,velocity,and temperature in the space after smoke generation were analyzed,and the motion law governing the smoke diffusion throughout the entire space was summarized.Combined with the experimental veri-fication of the smoke environment laboratory,the results showed that the smoke plume changed from fan-shaped to umbrella-shaped during smoke generation,and then continued to spread around.Meanwhile,the mass concentration of smoke in the space decreased from the middle outward;the changes in temperature and velocity were small and stable.In the diffusion stage(after 900 s),the mass concentration of smoke above 0.8 m was relatively uniform across an area of smoke that was 12 m thick.The concentration decreased over time,following a consistent decreasing trend,and the attenuation was negligible in a very short time.Therefore,this system was suitable for conducting experimental research on laser fuzes in a smoke environment.Owing to the stability of the equipment and facilities,the setup could reproduce the same experimental smoke environment by artificially controlling the smoke emission of the smoke agent.Overall,this work provides a theoretical reference for subsequent research efforts regarding the construction of uniform smoke environments and evaluating laser transmission characteristics in smoky environments.

Experimental Research on Lag Time of Iron Point-type Fire Detectors

The Influence of Mask on Lag Time of Point Fire Detector

Analysis of Temporal and Spatial Distribution Characteristics of Ammonium Chloride Smoke Particles in Confined Spaces

Study on the start time of mechanical exhaust system in economical building

Numerical Prediction Method for the Time History Response of Spot-Type Smoke Detectors to Fire Signals

Lag Time of Fire Plume in Aircraft Cargo Compartment Fires at Reduced Pressures

Experimental Study on Interference Source of Smoke Fire Detector in Religious Building Environment

Performance Of Point Type Smoke Detectors In Iso Fire Tests Under Different Altitude Areas

INFLUENCE ON PERFORMANCE OF SMOKE FIRE DETECTORS BY VELOCITY

Study on Response Time Hysteresis Model of Smoke Detectors in Aircraft Cargo Compartment

Research on reducing electromagnetic disturbance of laboratory-made ultrasonic detection devices

Experimental Analysis on Nuisance Immunity of Smoke Detectors

Experimental Study on Response Sensitivity of Smoke Detectors in High Flow Velocity

A Prediction Model of Point-Type Smoke Detector Response Signal Variation in High Altitude Area

Influence of Compartment Fire Behavior at Ignition and Combustion Development Stages on the Operation of Fire Detectors

Technical research on test method of the socket and switch of temperature monitoring alarm function

Smoke Temperature Near the Tunnel Ceiling and above the Fire Source at Different Longitudinal Ventilation Velocities

Test on Delay Time of Hi-safe Detonator

Reduction of response time of fire detection and containment systems in compartments

Full Scale Experimental Studies on the Response Characteristics and Applicability of Fire Automatic Alarm System in a Road Tunnel

Sensitivity Evaluation of Smoke Fire Detectors