Abstract:In response to the demand for short-range detection of anti-smoke environment interference by laser fuzes,this study proposes a smoke environment simulation of non-uniform continuous point source diffusion and investigates an experimental laboratory smoke environment using an ammonium chloride smoke agent.The particle size distribution,composition,and mass flow distribution of the smoke were studied.Based on a discrete phase model and a k-ε turbulence model,a numerical simulation was developed to model the smoke generation and diffusion processes of the smoke agent in a confined space.The temporal and spatial distribution characteristics of the smoke mass concentration,velocity,and temperature in the space after smoke generation were analyzed,and the motion law governing the smoke diffusion throughout the entire space was summarized.Combined with the experimental veri-fication of the smoke environment laboratory,the results showed that the smoke plume changed from fan-shaped to umbrella-shaped during smoke generation,and then continued to spread around.Meanwhile,the mass concentration of smoke in the space decreased from the middle outward;the changes in temperature and velocity were small and stable.In the diffusion stage(after 900 s),the mass concentration of smoke above 0.8 m was relatively uniform across an area of smoke that was 12 m thick.The concentration decreased over time,following a consistent decreasing trend,and the attenuation was negligible in a very short time.Therefore,this system was suitable for conducting experimental research on laser fuzes in a smoke environment.Owing to the stability of the equipment and facilities,the setup could reproduce the same experimental smoke environment by artificially controlling the smoke emission of the smoke agent.Overall,this work provides a theoretical reference for subsequent research efforts regarding the construction of uniform smoke environments and evaluating laser transmission characteristics in smoky environments.

The Influence of Mask on Lag Time of Point Fire Detector

Experimental Research on Lag Time of Iron Point-type Fire Detectors

Analysis of Temporal and Spatial Distribution Characteristics of Ammonium Chloride Smoke Particles in Confined Spaces

A Method for Standardized Wear Detection of Masks Based on Key Point Detection.

The Simulation of the Sampling Pipes and Sampling Holes Network with an Aspirating Smoke Detector

Virtual Simulation of the Effect of FMCW Laser Fuse Detector's Component Performance Variability on Target Echo Characteristics under Smoke Interference

Virtual Simulation of the Effect of FMCW Laser Fuse Detector’s Component Performance Variability on Target Echo Characteristics under Smoke Interference

INFLUENCE ON PERFORMANCE OF SMOKE FIRE DETECTORS BY VELOCITY

Performance Of Point Type Smoke Detectors In Iso Fire Tests Under Different Altitude Areas

Experimental Study on Interference Source of Smoke Fire Detector in Religious Building Environment

New Method to Improve the Reliability and Accuracy of Fire Detector

Study on the start time of mechanical exhaust system in economical building

Study on Time Factors in the Smoke Control Process of Highway Tunnel Fires

Research on multi-detector real-time fire alarm technology based on signal similarity

Sensitivity of point-type smoke fire detectors in plateau environment of Tibet

A Prediction Model of Point-Type Smoke Detector Response Signal Variation in High Altitude Area

A novel sensor network based real-time automatic longitudinal ventilation smoke control system for tunnels: A numerical investigation

Influence of Compartment Fire Behavior at Ignition and Combustion Development Stages on the Operation of Fire Detectors

Influence of Air Flow Patterns on Smoke Dispersion in Multi-functional Gymnasia

Experimental Analysis on Nuisance Immunity of Smoke Detectors

Research on pulse laser detection anti-interference method in smoke environment