Abstract:Cobalt silicide (CoSi2) islands have been formed by the deposition of thin films (~0.1 to 0.3 nm) of cobalt on clean Si(111) and Si(100) substrates in ultrahigh vacuum (UHV) followed by annealing to ~880 degrees C. Conducting atomic force microscopy has been performed on these islands to characterize and measure their current-voltage (I-V) characteristics. Current-voltage curves were analyzed using thermionic emission theory to obtain the Schottky barrier heights and ideality factors between the silicide islands and the silicon substrates. Current-voltage measurements were performed ex situ for samples ("passivated surfaces") where the silicon surface surrounding the islands was passivated with a native oxide. Other samples ("clean surfaces") remained in UHV while I-V curves were recorded. By comparing barrier heights and ideality factors for islands on both surfaces, the effects of the non-passivated surfaces on conduction were studied. The clean surface barrier heights were found to be ~0.2 to 0.3 eV below barrier heights measured from similar islands on passivated surfaces. The reduced Schottky barrier is mainly attributed to Fermi level pinning by non-passivated surface states of the clean silicon surface. However, the measured barrier heights of the clean surface islands are equivalent on both Si(111) and Si(100), suggesting that the non-passivated surfaces are influenced by cobalt impurities. Furthermore, the barrier heights of islands on the clean surfaces are lower than due to Fermi level pinning alone and the additional barrier height lowering is primarily attributed to spreading resistance effects. Schottky barrier inhomogeneity may also cause additional barrier height lowering and non-ideality in the contacts. The clean surface barrier heights decreased and the ideality factors increased with decreasing temperature, which is attributed to the temperature variation of the Fermi level.

Solid-Phase Reaction And Schottky Contact Properties Of Co/N-Poly-Si0.84ge0.16/N-Si(100)

Solid-Phase Reaction Between Co, Ni/n-poly-Si0.84Ge0.16 and Schottky Barrier Properties of the Formed Contacts

Schottky Contact Properties of Ni/n-poly-Si0.87Ge0.13/n-Si(100) Heterostructure

The inhomogeneity of Co/p-poly-Si0.84Ge0.16 Schottky contact

Characterization of Schottky barrier contact between ultra thin epitaxial CoSi2/n-Si

The inhomogeneity of Co/p-poly-Si/sub 0.84/Ge/sub 0.16/ Schottky contact

Schottky Barrier Characteristics of Polycrystalline and EpitaxialCoSi2/n-Si(111) Contacts Formed by Solid State Reaction

Schottky Barrier Characteristics of Ternary Silicide Co1−xNixSi2 on N-Si(1 0 0) Contacts Formed by Solid Phase Reaction of Multilayer

Electrical Characteristics of Cosi2/N-Si(100) Schottky Barrier Contacts Formed by Solid State Reaction

I-V-T studies on ternary silicide Co1-xNixSi2/n-Si Schottky contacts

Ballistic electron emission microscopy studies of the temperature dependence of Schottky barrier height distribution in CoSi2/n-Si(1 0 0) diodes formed by solid phase reaction

Electrical Characterization And Physical Analysis Of Epitaxial Cosi2 Grown From The Si<100>/Ti/Co System

Schottky barrier height lowering induced by CoSi 2 nanostructure

Pt interlayer effects on Ni germanosilicide formation and contact properties

Barrier height inhomogeneities of epitaxial CoSi2 Schottky contacts on n-Si (100) and (111)

Ballistic Electron Emission Microscopy Studies Of The Temperature Dependence Of Schottky Barrier Height Distribution In Cosi2/N-Si(100) Diodes Formed By Solid Phase Reaction

A Beem Study of Schottky Barrier Height Distributions of Ultrathin Cosi2/N-Si(100) Formed by Solid Phase Epitaxy

Conducting Atomic Force Microscopy Studies of Nanoscale Cobalt Silicide Schottky Barriers on Si(111) and Si(100)

The material characterization of nickel germanosilicides on SiGe/Si substrate and the contact size effect on Schottky diodes

Formation and Characterization of Spe Grown Ultra-Thin Cobalt Disilicide Film

Electrical Properties of PolySiGe Grown by Metal-Induced Growth