Abstract:Equipping pin-fins in the blade trailing edge is an significant method for enhancing heat transfer. In order to obtain a geometry of pin-fins with good heat transfer effect and small friction factor, six pin-fins (circular, elliptic, oblong, teardrop, lancet and NACA) are selected. The flow and heat transfer features of the rectangular channel with the staggered pin-fins were numerically studied through FLUENT software. The channels with different pin-fins have the same relative spanwise pitch (S/D=2.5) and streamwise pitch (X/D=2.5), and the range of Reynolds number is 5 x10(3) to 3 x 10(4). The applicability and accuracy of five turbulence models (Standard kappa-epsilon, Realizable kappa-epsilon, RNG K-E, Standard kappa-omega and SST kappa-omega) are checked by comparing the numerically predicted results with the experimental from literature. It is found that the Realizable K-C model is better at capturing the microstructure of flow field and has higher precision in predicting the averaged Nusselt number on the heated surface. For the six pin-fins, the leading edge is surrounded by a "U-shaped" strong heat exchange zone, but the vortex systems in the trailing edge are different from each other. Compared to the circular pin-fin, the oblong pin-fin has the best heat transfer enhancement effect, but the friction factor of channel is also larger. While the NACA pin-fin has the lowest friction factor, and the heat transfer effect is second only to the oblong. NACA pin-fin may be applied in blade trailing edge cooling by further optimizing the relative position of the pin-fins in the channel.

CFD study on serrated fin performance at different flow angles

Numerical auxiliary study of charge-air cooler design

Analysis of Heat Transfer and Flow Characteristics over Serrated Fins with Different Flow Directions

Numerical study and experimental verification of transverse direction type serrated fins and field synergy principle analysis

3D Numerical Simulation of the Air Flow Among the Multi-louvered Fins

Numerical simulation of slit fin cell's flow and heat transfer

Numerical Study of Fluid Flow and Heat Transfer in Plate-Fin Heat Transfer Exchanger of Htgr

Numerical Study of Effect of Liquid Viscosity Variation on Fins Surface Performance

Experimental and numerical investigation on flow and heat transfer characteristics of a multi-waves internally spiral finned tube

Numerical Modeling and Experimental Verification of Flow and Heat Transfer over Serrated Fins at Low Reynolds Number

Numerical investigation on fin configuration improvement of 2 K sub-atmospheric plate-fin heat exchangers for the superfluid helium cryogenic systems

Three-dimensional Numerical Simulation of Flow and Heat Transfer on Slit Fins

Experiment and Numerical Simulation for Characteristics of Two Slotted Fins

Numerical Investigation on Serrated Fin of Sub-Atmosphere Plate-Fin Heat Exchanger Used in Superfluid Helium System

Three-dimensional numerical simulation on flow and heat transfer in spirally inner finned tubes

Three dimensional numerical simulation on surface performance of a plate-fin heat exchanger.

CFD Simulation of Fluid Flow and Heat Transfer in Channels of Plate-Fin Heat Exchangers

Numerical Simulation and Experimental Verification on Thermal Performance of A Novel Fin-Plate Thermosyphon

Numerical Study on Flow and Heat Transfer Characteristics of Pin-Fins with Different Shapes

EXPERIMENTAL AND NUMERICAL STUDY ON HEAT TRANSFER CHARACTERISTICS OF THREE-ROW SLOTTED FINS WITH SMALL DIAMETERS

Parametrical Numerical and Experimental Investigation on Heat Transfer and Friction Characteristics of Offset Strip Fins