Abstract:Thermal performance of a shell-and-tube heat exchanger is investigated numerically using ANSYS FLUENT software under various conditions. Before proceeding with simulations, sensitivity analysis is performed for both mesh grid and turbulence model and the results are compared and validated with results obtained from Bell-Delaware method. The numerical study is consisted of three parts: First the effect of tube wall relative roughness and Reynolds number on total heat transfer and pressure drop is investigated. In the second part, effect of vertical segmented tube fins on heat transfer is studied under two independent adjustable parameters, namely fin pitch and fin height while surface roughness is fixed. Finally, a novel design of fins (helical fin) is proposed and its influence on thermal performance of the heat exchanger is investigated and results are compared to no-fin and segmented fin configurations. It is found that tube fins in general enhance overall efficiency of the heat exchanger. The efficiency is increased by 9.5% and 6% when the proposed helical fins and segmented fins are used respectively. CFD results purpose the efficiency is increased by increasing fin height, but decreased by increasing fin pitch. Helical fins increase effectiveness of heat exchanger by 17% compared to plain tubes. Although increasing surface roughness increases the efficiency, it leads to faster corrosion which means higher maintenance costs and is not desirable. The efficiency of the heat exchanger therefore can be prominently increased when combination of low surface roughness and helical fins with smaller pitch and larger height are used.

Numerical study and experimental verification of transverse direction type serrated fins and field synergy principle analysis

Study on heat transfer and friction characteristics in fin-tube heat exchangers used for electrical machines cooling

Flow and Heat Transfer Analysis of Perforated Fin in Compact Heat Exchanger

Numerical auxiliary study of charge-air cooler design

Numerical Modeling and Experimental Verification of Flow and Heat Transfer over Serrated Fins at Low Reynolds Number

Analysis of Heat Transfer and Flow Characteristics over Serrated Fins with Different Flow Directions

Numerical Study of Fluid Flow and Heat Transfer in Plate-Fin Heat Transfer Exchanger of Htgr

Numerical analysis on heat transfer and flow resistance performances of a heat exchanger with novel perforated wavy fins

Field Synergy Analysis on Convective Heat Transfer and Fluid Flow of a Novel Triangular Perforated Fin

CFD study on serrated fin performance at different flow angles

Numerical Study of Effect of Liquid Viscosity Variation on Fins Surface Performance

Numerical investigation on fin configuration improvement of 2 K sub-atmospheric plate-fin heat exchangers for the superfluid helium cryogenic systems

Numerical Simulation and Experimental Verification on Thermal Performance of A Novel Fin-Plate Thermosyphon

Field Synergy Analysis of Heat Transfer Enhancement on Slit Wavy Fins

Numerical investigation on effects of using segmented and helical tube fins on thermal performance and efficiency of a shell and tube heat exchanger

Numerical study on hydrodynamic characteristics of plate-fin heat exchanger using porous media approach

Numerical studies on heat transfer and pressure drop characteristics of flat finned tube bundles with various fin materials

Experimental Study of Boiling Heat Transfer and Flow Characteristics in Fin Channels with Variable Cross Section

Numerical analysis of the flow and heat transfer characteristics of a staggered perforated louver-finned heat exchanger

Experimental and numerical study and comparison of performance for herringbone wavy fin and enhanced fin with convex-strips in fin-and-tube heat exchanger

Performance Investigation of an Innovative Offset Strip Fin Arrays in Compact Heat Exchangers