Abstract:An apparatus for transferring thermal energy across an impermeable barrier between two or more fluids is a heat exchanger. The effective transmission of heat from a hot fluid to a cold fluid is its primary goal. The temperature differential between the two fluids directly affects this heat transfer. Using CFD study with FLUENT 2020 R1, the performance characteristics of the compact plate fin heat exchanger's improved surfaces are examined. The simulation of heat transfer and flow encompassed a variety of velocities including completely turbulent regions. The pressure, temperature, and velocity contours were taken from the Fluent simulations. To determine the heat exchanger's flow and heat transfer performance, numerical analysis has been done. Since boundary conditions are crucial to CFD, they have been carefully chosen. The flow field, heat transfer, thickness, and wavelength were all predicted using the software code for a range of air to water velocities. Three distinct wavelengths of numerical simulations for a plate-fin heat exchanger were used in the study (10, 20, and 30). There were changes to the fin thickness, entry locations, and air and water entry velocities. Solid Works and Ansys were used to create the geometry for the three-level fin models that were placed inside the heat exchanger, both with and without a cover. For determining the heat exchanger's geometry and fin isometry, three levels measuring 19.6 mm in height and 53.64 mm in width were constructed. The fins have a thickness of 0.2 to 0.4 mm. As the air and water velocities vary, so does the temperature inside the heat exchanger. Because the topmost layer is a warm stream's flow channel, the temperature rises there, whereas the opposite effect is seen close to the bottom layer. Convection heat transmission to the surroundings and conduction heat transfer through the heat exchanger's side plates are the causes of fluid temperature fluctuations in the depth direction.

CFD Simulation of Fluid Flow and Heat Transfer in Channels of Plate-Fin Heat Exchangers

CFD Techniques for the Design of Plate-fin Heat Exchangers with Plain Fins and Serrated Fins

Flow and Heat Transfer Analysis of Perforated Fin in Compact Heat Exchanger

Numerical Study of Fluid Flow and Heat Transfer in Plate-Fin Heat Transfer Exchanger of Htgr

Three dimensional numerical simulation on surface performance of a plate-fin heat exchanger.

Three-Dimensional Numerical Simulation on the Laminar Flow and Heat Transfer in Four Basic Fins of Plate-Fin Heat Exchangers

Numerical simulation of slit fin cell's flow and heat transfer

Heat Transfer and Pressure Drop in Plate Fin Heat Exchangers: A Numerical Approach

A numerical and experimental study of chevron, corrugated-plate heat exchangers

Numerical and Experimental Study on the Flow and Heat Transfer Performance of a Plate-Fin Heat Exchanger Using for Environmental Protection

CFD-based structure optimization of plate bundle in plate-fin heat exchanger considering flow and heat transfer performance

Numerical simulation of heat transfer and flow characteristics for plate fin-and-tube heat exchanger with ring-bridge slit fins

Effects of Distribution Channel Dimensions on Flow Distribution and Pressure Drop in a Plate‐Fin Heat Exchanger

Numerical investigation on fin configuration improvement of 2 K sub-atmospheric plate-fin heat exchangers for the superfluid helium cryogenic systems

Numerical study on hydrodynamic characteristics of plate-fin heat exchanger using porous media approach

CFD study on serrated fin performance at different flow angles

Three-Dimensional Numerical Simulation on Laminar Heat Transfer and Fluid Flow Characteristics of Strip Fin Surface With X-Arrangement of Strips

Experimental Study of Boiling Heat Transfer and Flow Characteristics in Fin Channels with Variable Cross Section

Numerical Study of the Air Inlet Angle Influence on the Air–side Performance of Plate-Fin Heat Exchangers

Influence of Fin Arrangement on Fluid Flow and Heat Transfer in the Inlet of a Plate-Fin Heat Exchanger

CFD modeling of industrial cold box with plate-fin heat exchanger: Focusing on phase change phenomenon