Abstract:This paper investigates the application of continuous input current charge pump power factor correction (CIC-CPPFC) techniques in electronic ballast. Comparing with traditional two-stage electronic ballast, it has fewer components and lower cost. The laboratory prototype of CIC-CPPFC electronic ballast for 50W UPS lamp is designed and tested in this paper. Experiment results verify that the single-stage electronic ballast can not only ignite RPS lamp with variable frequency, it can also hold constant power when the input voltage varies in a wide range. It has various malfunctions protection function including open circuit, short circuit, or hot lamps. During the starting-up period, the protection circuit will block the half-bridge inverter for a long period if the lamp in hot state. After the protection time, the lamp isn't in hot state, and it will be turned on again. In this paper, more than 0.99 power factor and less than 11% THD can be achieved.

Application of Charge Pump PFC in Electronic Ballast for Metal Halide Lamp

A Digital Controlled Ballast for Metal Halide Lamp

Electronic Ballast for Low Power High Pressure Sodium Lamp Based on Charge Pump Power Factor Correction Technique

Electronic Ballast For High Pressure Sodium Lamp Based On Charge Pump Power Factor Correction Technique

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

Electronic Ballast for MHL Based on ARM Microcontroller

A Two-Stage Low-Frequency Square-Wave Electronic Ballast for Metal Halide Lamps Using Peak-Current Control Mode

New Control Strategy for a Two-Stage Low-Frequency Square-Wave Electronic Ballast for MHD Lamp

New electronic ballast circuits for high intensity discharge lamps

Investigation On The Start-Up Of Low Wattage Metal Halide Lamp Controlled By Low-Frequency Square-Wave Ballast

An Improved Dimmable Electronic Ballast with T-Type Resonant Inverter at Very High Frequency

Design of High Frequency Fluorescent Lamp IC

Analysis on a Novel Electronic Ballast for Low-wattage MH Lamp and Its Control Strategy

Study of Igniter in Low-Frequency Square Wave Electronic Ballasts for Metal Halide Lamps

Power Control Strategy of Electronic Ballast for HID Lamps

Novel single stage single switch PFC converter with constant power control for ballast for medium HID lamps

Design for LCLC Resonant Inverter Circuit in High-power Electronic Ballast

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

Design of a Digital Controller for High Frequency HID Lamp Ballast

Control Strategy of A Novel Two-Stage Acoustic Resonance Free Electronic Ballast for Hid Lamps

A Novel Low-Frequency Electronic Ballast for HID Lamps