Abstract:This paper presents a detailed study on the transient response and stability of the automatic gain control (AGC) with a proportion-integral (PI) controller for a MEMS vibratory gyroscope, which constructs a closed-loop control system to make the gyroscope achieve a constant amplitude vibration at its resonant frequency. The nonlinear mathematical model for the control system is established by applying the averaging and linearization method, which is evaluated through numerical simulations. The stability and convergence characteristics of the whole loop are investigated by using the phase plane method and Routh-Hurwitz criterion. The analysis provides a quantitative methodology for selecting the system parameters to approach stability and an optimal transient response. The negative impact induced by drift of the resonant frequency and Q-factor is also discussed. Simulation results predicted by the model are shown to be in close agreement with the experimental results carried out on a doubly decoupled bulk micromachined gyroscope. By optimizing the control parameters, the measured rising time is less than 100 ms without obvious overshoot. The setting time of the whole loop is less than 200 ms with the relative fluctuation of velocity amplitude within approximately 16 ppm for an hour. The resulting overall performance of the gyroscope is tested under atmospheric pressure. The resonant frequencies and the Q-factor of the drive mode and sense mode are 2.986 kHz, 213 and 3.199 kHz, 233, respectively. The gyroscope achieves a scale factor of 27.6 mV/deg/s with nonlinearity less than 120 ppm in the full-scale range of 800 degrees s(-1). The threshold of sensitivity is measured to be about 0.005 degrees s(-1) with noise equivalent angular rate evaluated to be 0.001 degrees/s/Hz(1/2).

Closed-loop Characteristics of Sense Axis of Vibratory Wheel Silicon Micromechanical Gyroscope

Closed loop control design for the sense mode of micromachined vibratory gyroscopes

A MICROMECHANICAL MODE-MATCHED GYROSCOPE USING STIFFNESS NONLINEARITY AND ELECTROSTATIC TUNING

A Bulk Micromachined Gyroscope With Improved Quality-Factors At Atmospheric Pressure

Design of a digital closed control loop for the sense mode of a mode-matching MEMS vibratory gyroscope

Force Rebalance Controller Synthesis for A Micromachined Vibratory Gyroscope Based on Sensitivity Margin Specifications

Performance Research of a Vibratory Wheel Micromechanical Gyroscope

Digital controller design for sense mode of micro-machined gyroscope

Analysis and Design of Drive Closed-Loop for Mems Vibratory Gyroscope

Design and Simulation of a Dual-Axis Sensing Decoupled Vibratory Wheel Gyroscope

The Analysis and Design of Closed-Loop Control System for MEMS Vibratory Gyroscopes

System Modelling of A Vibratory Micromachined Gyroscope with Bar Structure

Theoretical Analysis and Numerical Simulation of Closed-Loop Self-Oscillation System for MEMS Vibratory Gyroscopes

Characterization of Modal Frequencies and Orientation of Axisymmetric Resonators in Coriolis Vibratory Gyroscopes

Design of Digital Demodulation Circuit for Closed Loop Control of Resonant MEMS Gyroscopes

Digital closed-loop controller design of a micromachined gyroscope based on auto frequency swept

High-performance Silicon Micromachined Resonant Gyroscope

A sub 0.8 degree per hour mode-matching MEMS vibratory gyroscope with closed loop control for the sense mode

Transient response and stability of the AGC-PI closed-loop controlled MEMS vibratory gyroscopes

Research of close loop control model for electrostatically levitated micro-gyroscope

A Closed-Loop System with DC Sensing Method for Vibratory Gyroscopes