Abstract:The nanoindentation hardnesses of a commercially available soda-lime glass, a tetragonal ZrO2 polycrystalline and a hot-pressed Si3N4 were measured in the peak load range from 7.5 to 500 mN. The experimental results revealed that, for each material, the measured hardness exhibits a peak-load- dependence, i.e., indentation size effect (ISE). Such a peak-load-dependence was then analyzed using the Meyer’ law, the Hay–Kendall approach, the proportional specimen resistance (PSR) model, the elastic recovery model and the modified PSR model. The analyses revealed that: (1) Meyer's law provides a satisfactory description for the experimental data for each material but cannot provide any knowledge of the origin of the observed ISE; (2) the Hays–Kendall approach, the elastic recovery model and the PSR model yield meaningless values of the parameters included in the corresponding equations, invalidating the applicability of these models in analyzing the ISE in the nanoindentation region; (3) the modified PSR model is sufficient for describing the observed ISE but the physical meaning of this model seems to be more complex than those proposed originally. For each material, the true hardness was also determined based on the PSR model, the elastic recovery model and the modified PSR model, respectively. It was found that the true hardness values deduced based on different models are similar with each other and this similarity was attributed to the similarity between the empirical equations adopted in these models.

Load-Dependence of the Measured Hardness of Ti(C,N)-Based Cermets

Load-dependence of Knoop Hardness of Al2O3–TiC Composites

Effect of metallic binder content on the microhardness of TiCN-based cermets

Influence of metallic binder content on the microhardness of TiCN-based cermet

Compositional Dependence of Hardness of (Ce,y)-Tzp/al2o3 Composites

Analysis of Load-Displacement Curves of Ceramics Measured with Low-Load Vickers Hardness Test: Indentation Size Effect

Examination of the Indentation Size Effect in Low-Load Vickers Hardness Testing of Ceramics

Meyer analysis of the indentation size effect in the low-load hardness of (Ce,Y)-TZP/Al2O3 composites

Influence of TiC particle size on the load-independent hardness of Al2O3–TiC composites

Load dependence of the apparent hardness of silicon nitride in a wide range of loads

Indentation Size Effect in Vickers Hardness Testing of NiO/8YSZ Composites

Load-Independent Hardness and Indentation Size Effect in Iron Aluminides

Nano-Indentation Properties of Tungsten Carbide-Cobalt Composites as a Function of Tungsten Carbide Crystal Orientation

Analysis of the Indentation Size Effect on the Apparent Hardness for Ceramics

Effect of peak load on the determination of hardness and Young's modulus of hot-pressed Si3N4 by nanoindentation

On the description of indentation size effect in hardness testing for ceramics: Analysis of the nanoindentation data

The Effect of Indenter Angle on the Microindentation Hardness

Load Dependence of Low-Load Knoop Hardness in Ceramics: a Modified PSR Model

On the Local Crack Resistance of Al2O3–TiC Composites Evaluated by Direct Indentation Method

Nanoindentation Characterization of Tetragonal Zirconia Polycrystalline Implanted by Titanium Ions with MEVVA Sources

Determination of the Load-Independent Hardness by Analyzing the Peak-Load-Dependence of the Unloading Slope in Nanoindentation