Abstract:The nanoindentation hardnesses of a commercially available soda-lime glass, a tetragonal ZrO2 polycrystalline and a hot-pressed Si3N4 were measured in the peak load range from 7.5 to 500 mN. The experimental results revealed that, for each material, the measured hardness exhibits a peak-load- dependence, i.e., indentation size effect (ISE). Such a peak-load-dependence was then analyzed using the Meyer’ law, the Hay–Kendall approach, the proportional specimen resistance (PSR) model, the elastic recovery model and the modified PSR model. The analyses revealed that: (1) Meyer's law provides a satisfactory description for the experimental data for each material but cannot provide any knowledge of the origin of the observed ISE; (2) the Hays–Kendall approach, the elastic recovery model and the PSR model yield meaningless values of the parameters included in the corresponding equations, invalidating the applicability of these models in analyzing the ISE in the nanoindentation region; (3) the modified PSR model is sufficient for describing the observed ISE but the physical meaning of this model seems to be more complex than those proposed originally. For each material, the true hardness was also determined based on the PSR model, the elastic recovery model and the modified PSR model, respectively. It was found that the true hardness values deduced based on different models are similar with each other and this similarity was attributed to the similarity between the empirical equations adopted in these models.

Examination of the Indentation Size Effect in Low-Load Vickers Hardness Testing of Ceramics

Analysis of Load-Displacement Curves of Ceramics Measured with Low-Load Vickers Hardness Test: Indentation Size Effect

Analysis of the Indentation Size Effect on the Apparent Hardness for Ceramics

Load Dependence of Low-Load Knoop Hardness in Ceramics: a Modified PSR Model

On the description of indentation size effect in hardness testing for ceramics: Analysis of the nanoindentation data

The Effect of Indenter Angle on the Microindentation Hardness

Indentation toughness of ceramics: A modified approach

Effect of Microcracking on the Energy-Balance Relationship for Hardness Testing of Ceramics

Indentation Size Effect in Vickers Hardness Testing of NiO/8YSZ Composites

An energy-balance analysis for the size effect in low-load hardness testing

Effect of porosity on the microhardness testing of brittle ceramics: A case study on the system of NiO-ZrO2

Indentation Size Effect: a Study Via the Mechanism-based Strain-Gradient Plasticity Theory

Microhardness, Indentation Size Effect and Real Hardness of Plastically Deformed Austenitic Hadfield Steel

The influence of crack forms on indentation hardness test results for ceramic materials

A Numerical Study of Indentation with Small Spherical Indenters

Load dependence of the apparent hardness of silicon nitride in a wide range of loads

Surface Effects on the Indentation of a Soft Layer on a Rigid Substrate with an Elliptical Cylinder Indenter

Load-Dependence of the Measured Hardness of Ti(C,N)-Based Cermets

QUASICONTINUUM ANALYSIS OF INDENTER SIZE EFFECT IN NANOINDENTATION TESTS

Nanoindentation Characterization of the Hardness of Zirconia Dental Ceramics