Abstract:The competition and balance mechanism between work hardening resulting from the surge in dislocations and material softening caused by plastic deformation during contact loading in Al 0.3 CoCrFeNi high-entropy alloy is unclear. The structural transformation and strain localization of Al 0.3 CoCrFeNi high-entropy alloy during nanoindentation are investigated using molecular dynamics, and the hardening-softening mechanism is discussed. The simulations demonstrate that the prismatic dislocation loop with independent nucleation is discovered for the first time in the [111] orientation. Dislocation multiplication and cross-slip lead to an increase in indentation resistance, resulting in work hardening. Free dislocation slip and dislocation annihilation accommodate plastic strain will reduce indentation resistance, resulting in plastic softening. Twin boundaries can effectively block dislocation propagation, which contributes to hardening. However, twin boundaries cause a softening effect in the later stage of plastic deformation owing to two reasons: (1) the formation of steps and the partial slip where the slip plane and Burgers vector are parallel to the twin boundary, (2) steps and local damage zones in twin boundaries become new nucleation sites for dislocations. The phase-field-crystal method confirms that Al 0.3 CoCrFeNi high-entropy alloy has the highest hardness when the twin spacing is 2.467 nm.

Compositional Dependence of Hardness of (Ce,y)-Tzp/al2o3 Composites

Meyer analysis of the indentation size effect in the low-load hardness of (Ce,Y)-TZP/Al2O3 composites

Hardness And Elastic Moduli Of High Pressure Synthesized Mob2 And Wb2 Compacts

Load-dependence of Knoop Hardness of Al2O3–TiC Composites

Load-Dependence of the Measured Hardness of Ti(C,N)-Based Cermets

Indentation Size Effect in Vickers Hardness Testing of NiO/8YSZ Composites

Influence of TiC particle size on the load-independent hardness of Al2O3–TiC composites

High‐Throughput Evaluation of Hardening Coefficients of Eight Alloying Elements in Magnesium

Hardness of single phase high entropy carbide ceramics with different compositions

Mechanical and Wear Characteristic of Y-TZP/Al2O3 Nanocomposites

Co2+‐Substitution Effect in Ce‐TZP/La M‐type Hexaferrite Composites

Comparison of sintering behavior and reinforcing mechanisms between 3Y-TZP/Al2O3(w) and 12Ce-TZP/Al2O3(w) composites: Combined effects of lanthanide stabilizer and Al2O3 whisker length

Hot-pressed ZrB2–SiC–YSZ Composites with Various Yttria Content: Microstructure and Mechanical Properties

Microstructure and Mechanical Response of TiB2/Al–Zn–Mg–Cu Composites with More Addition of Zn

On the Local Crack Resistance of Al2O3–TiC Composites Evaluated by Direct Indentation Method

Effect of yttrium on phase composition and microstructure of FeCoNiAlCrB high entropy alloys

Hardening-softening of Al 0.3 CoCrFeNi high-entropy alloy under nanoindentation

Strengthening mechanisms of AlCoCrFeNi-WC-Ti coating from first-principles calculations

Statistical variability in the indentation toughness of TiCN particle reinforced Al2O3 composite

Investigation of abrasive wear resistance and wear mechanism of composite alloys

In Situ Processing of Y-TZP/M-Type Hexaferrite Composite.