Abstract:Using the end discharge of micro-rod-shaped electrode to scan layer by layer, micro-electrical discharge machining (EDM) can fabricate complex 3D micro-structures. During the machining process, the discharge state is broken frequently due to the wear of the tool electrode and the relative scanning motion. To keep a favorable discharge gap, the feed spindle of the tool electrode needs the characteristics of high-frequency response and high resolution. In this study, an experimental system with a macro/micro-dual-feed spindle was designed to improve the machining performance of servo scanning 3D micro-EDM (3D SSMEDM), which integrates an ultrasonic linear motor as the macro-drive and a piezoelectric (PZT) actuator as micro-feeding mechanism. Based on LabVIEW and Visual C++ software platform, a real-time control system was developed to control coordinately the dual-feed spindle to drive the tool electrode. The micro-feed motor controls the tool electrode to keep the favorable discharge gap, and the macro-drive motor realizes long working range by a macro/micro-feed conversion. The emphasis is paid on the process control of the 3D SSMEDM based on macro/micro-dual-feed spindle for higher machining accuracy and efficiency. A number of experiments were carried out to study the machining performance. According to the numerical control (NC) code, several typical 3D micro-structures have been machined on the P-doped silicon chips. Our study results show that the machining process is stable and the regular discharge ratio is higher. Based on our fundamental machining experiments, some better-machined effects have been gained as follows. By machining a micro-rectangle cavity (960μm×660μm), the machined depth error can be controlled within 2%, the XY dimensional error is within 1%, the surface roughness Ra reaches 0.37μm, and the material removal rate is about 1.58×104μm3/s by using a tool electrode of Φ=100μm in diameter. By machining multi-micro-triangle cavities (side length 700μm), it is known that the machining repeatability error is <0.7%.

The Development of Three-dimensional Electrochemical Generating Micromachining Equipment

MOEMS 3D microstructure preparation method based on novel localized electrochemical deposition

A study on wire electrochemical micromachining for fabrication of microgrooves

Gap status identification and control of wire electrochemical micromachining

Electrochemical micro-machining of high aspect ratio micro-tools with a reverse conical shape tip using electrolyte liquid membrane

Chemical Etching Processes at the Dynamic GaAs/Electrolyte Interface in the Electrochemical Direct-Writing Micromachining

Micro Electro Machining Technologies for Industrial Application

Localized electrochemical micromachining with gap control

Servo scanning 3D micro-EDM based on macro/micro-dual-feed spindle

Sinking ECDM micro-milling of micro-channels with a customized electrode

Micro-Fabrication and Monitoring of Three-Dimensional Microstructures Based on Laser-Induced Thermoplastic Formation

Micro-electrochemical Machine Tool Used in Micro Parts Manufacturing

Experimental and numerical investigations into the fabrication of alumina ceramic surface microchannel by electrochemical discharge machining

Research on the Key Technologies of Micro Electro Discharge Machining

A study of micro-EDM and micro-ECM combined milling for 3D metallic micro-structures

Research On Micro Ecm Using Micro Array Electrode

The Multi-Physics Analysis for a Novel Tool Structure to Improve the Accuracy in Electrochemical Micro-Machining

Modeling and Fabrication of Microhole by Electrochemical Micromachining Using Retracted Tip Tool

Micro Array Hole Formation in Glass Using Electrochemical Discharge Machining

CAD/CAM Integration System of 3D Micro EDM

Electrochemical Jet Machining in Deep-Small Holes with Gas Assistance: Generating Complex Features on Internal Surfaces