Abstract:One of the challenges for improving the performance and cost-effectiveness of solid oxide fuel cells (SOFCs) is the development of effective interconnect materials. A widely used interconnect ceramic for SOFCs is doped lanthanum chromite. In this paper, we report a doped lanthanum chromite, La0.7Ca0.3CrO3−δ (LCC)+xwt.% Gd0.2Ce0.8O1.9 (GDC) (x=0–10), with improved electrical conductivity and sintering capability. In this composite material system, LCC+GDC were prepared by an auto-ignition process and the electrical conductivity was characterized in air and in H2. The LCC powders exhibited a better sintering ability and could reach a 94.7% relative density at 1400°C for 4h in air and with the increase of GDC content the relative density increased, reached 98.5% when the GDC content was up to 10wt.%. The electrical conductivity of the samples dramatically increased with GDC addition until a maximum of 134.48Scm−1 in air at 900°C when the materials contained 3wt.% GDC. This is 5.5 times higher than pure LCC (24.63Scm−1). For the sample with a 1wt.% GDC content, the conductivity in pure H2 at 900°C was a maximum 5.45Scm−1, which is also higher than that of pure LCC ceramics (4.72Scm−1). The average thermal expansion coefficient (TEC) increased with the increase of GDC content, ranging from 11.12 to 14.32×10−6K−1, the majority of which unfortunately did not match that of 8YSZ. The oxygen permeation measurement presented a negligible oxygen ionic conduction, indicating that it is still an electronically conducting ceramic. Therefore, it is a very promising interconnect material for higher performance and cost-effectiveness for SOFCs.

Synthesis and Electrical Conductivity of Perovskite Gd1−xCaxCrO3 (0⩽x⩽0.3) by Auto-Ignition Process

Synthesis and electrical conductivity of perovskite Gd1-xCa xCrO3 (0≤x≤0.4) by ignition process

Influence of Cr deficiency on sintering, thermal expansion and electrical properties of La0.75Sr0.25Cr1−xO3−δ as a SOFC interconnect material

Preparation and properties of ceramic interconnecting materials, La0.7Ca0.3CrO3-δ doped with GDC for IT-SOFCs

Low temperature sintering ability and electrical conductivity of SOFC interconnect material La0.7Ca0.3Cr0.97O3

Characterization of A-site Excessive Perovskite La0.7–xSmx+0.02Ca0.3CrO3–δ

PREPARATION AND CHARACTERIZATION OF Gd_(1-x)Sr_xCoO_(3-δ) AS INTERMEDIATE TEMPERATURE SOLID OXIDE FUEL CELL CATHODE MATERIAL

Evaluation of A-site deficient Sr1−xSc0.175Nb0.025Co0.8O3−δ (x=0, 0.02, 0.05 and 0.1) perovskite cathodes for intermediate-temperature solid oxide fuel cells

Study on Synthesis by Microwave-aided Sol-gel Process and Sintering Abilities of La_(0.7)Ca_(0.3)CrO_(3-δ) Fine Powders

Preparation and characterization of Gd1-xSrxCoO 3-δ and Gd0.8Sr0.2Co1-yFe yO3-δ

A High Performance Interconnecting Ceramics for Solid Oxide Fuel Cells (Sofcs)

Synergistic electron doping and ion conductive phase incorporating of SrCoO3- as desirable cathode materials for intermediate-temperature solid oxide fuel cells

Synthesis and Characterization of (gd, Y)-Doped Ceria Electrolytes for Solid Oxide Fuel Cell

Microwave assisted synthesis,sinterability and properties of Ca-Zn co-doped LaCrO_3 as interconnect material for IT-SOFCs

High Performance Gd3+ and Y3+ Co-Doped Ceria-Based Electrolytes for Intermediate Temperature Solid Oxide Fuel Cells

Influence of Cr Deficiency on Sintering Character and Properties of SOFC Interconnect Material La0.7Ca0.3Cr1−xO3−δ

Evaluation of simple, easily sintered La0.7Ca0.3Cr0.97 O3-δ perovskite oxide as novel interconnect material for solid oxide fuel cells

Preparation and Properties of Gd3+ and Y3+ Co-Doped Ceria-Based Electrolytes for Intermediate Temperature Solid Oxide Fuel Cells

Characterization And Properties Of La1-Xsrxfeo3-Delta With Perovskite-Type Structure

Performances of Gd0.8Sr0.2CoO3 Powders for IT-SOFC Cathodes Prepared by Glycine-Nitrate Process

Evaluation of Li2O As an Efficient Sintering Aid for Gadolinia-Doped Ceria Electrolyte for Solid Oxide Fuel Cells