Abstract:This research explores the behavior of Co40Fe40W10B10 when it is sputtered onto Si(100) substrates with a thickness (tf) ranging from 10 nm to 100 nm, and then altered by an annealing process at temperatures of 200 °C, 250 °C, 300 °C, and 350 °C, respectively. The crystal structure and grain size of Co40Fe40W10B10 films with different thicknesses and annealing temperatures are observed and estimated by an X-ray diffractometer pattern (XRD) and full-width at half maximum (FWHM). The XRD of annealing Co40Fe40W10B10 films at 200 °C exhibited an amorphous status due to insufficient heating drive force. Moreover, the thicknesses and annealing temperatures of body-centered cubic (BCC) CoFe (110) peaks were detected when annealing at 250 °C with thicknesses ranging from 80 nm to 100 nm, annealing at 300 °C with thicknesses ranging from 50 nm to 100 nm, and annealing at 350 °C with thicknesses ranging from 10 nm to 100 nm. The FWHM of CoFe (110) decreased and the grain size increased when the thickness and annealing temperature increased. The CoFe (110) peak revealed magnetocrystalline anisotropy, which was related to strong low-frequency alternative-current magnetic susceptibility (χac) and induced an increasing trend in saturation magnetization (Ms) as the thickness and annealing temperature increased. The contact angles of all Co40Fe40W10B10 films were less than 90°, indicating the hydrophilic nature of Co40Fe40W10B10 films. Furthermore, the surface energy of Co40Fe40W10B10 presented an increased trend as the thickness and annealing temperature increased. According to the results, the optimal conditions are a thickness of 100 nm and an annealing temperature of 350 °C, owing to high χac, large Ms, and strong adhesion; this indicates that annealing Co40Fe40W10B10 at 350 °C and with a thickness of 100 nm exhibits good thermal stability and can become a free or pinned layer in a magnetic tunneling junction (MTJ) application.

Effects of Bias Voltage and Annealing on the Structure and Mechanical Properties of WC0.75N0.25 Thin Films

Effect of High Temperature Annealing on the Microstructure and Thermal Shock Resistance of Tungsten Coatings Grown by Chemical Vapor Deposition

Effects of Bias Voltage and Substrate Temperature on the Mechanical Properties and Oxidation Behavior of CrWSiN Films

Investigating the Effect of Bias Voltage on the Microstructural Thermal Stability and Tribological Performance of N-doped Hydrogenated Diamond-Like Carbon Coatings

Effects of Substrate Bias on Structure and Mechanical Properties of (alcrnbsitiv)n Coatings

Effects of the negative bias voltages and post-annealing process on the crystallization and martensite formation of Ti-Zr-Hf-Co-Ni-Cu high-entropy thin film

Influence of Substrate Bias on Properties of TiN Films with X-ray Photoelectron Spectroscopy and Atomic Force Microscopy Studies

Effect of substrate bias on nanoindentation hardness and microstructure of polycrystalline copper thin films

Annealing Effect on the Characteristics of Co40Fe40W10B10 Thin Films on Si(100) Substrate

Effects of Composition and Thermal Annealing on the Mechanical Properties of Silicon Oxycarbide Films

Effects of Bias Voltage on Structure and Properties of Tial-Doped A-C:H Films Prepared by Magnetron Sputtering

Effects of substrate temperature and bias voltage on mechanical and tribological properties of cosputtered (TiZrHfTa)N x films

Dependences of Amorphous Structure on Bias Voltage and Annealing in Silicon–carbon Alloys

Experimental study and influence mechanismof the properties of α-C:H thin film at different bias voltages

Effects of Substrate Bias on Structure and Mechanical Properties of Alcrtiwnbta Coatings

Impact of Annealing on Magnetic Properties and Structure of Co40Fe40W20 Thin Films on Si(100) Substrate

Effect of annealing on the mechanical and scratch properties of BCN films obtained by magnetron sputtering deposition

Effects of Negative Bias on the Structural, Topological and Tribological Properties of Amorphous Carbon Films Prepared by Magnetron Sputtering

Effects of bias voltage on the structure, mechanical properties and tribological properties of TaB x films at elevated temperatures

Effects of substrate bias on the structure and mechanical properties of (Al 1.5 CrNb 0.5 Si 0.5 Ti)N x coatings

Effect of bias voltages on microstructure and properties of (TiVCrNbSiTaBY)N high entropy alloy nitride coatings deposited by RF magnetron sputtering