Abstract:This article investigates the evolution of surface transverse cracks in Q345 steel during the hot‐rolling process. A slab rolling model is established based on the onsite rolling process parameters to analyze the effects of different rolling processes on the morphology and aspect ratio of surface cracks. The study summarizes the evolutionary behavior of surface transverse cracks under various rolling process parameters. This article examines the evolutionary behavior of transverse surface cracks in Q345 steel during the hot‐rolling process under various rolling conditions. "V"‐shaped cracks are prefabricated on the billet surface for laboratory hot‐rolling tests, and a corresponding rolling model is developed to validate its accuracy. The slab rolling model is established based on actual onsite rolling process parameters. The aim is to analyze the effects of different rolling conditions on the surface crack morphology and aspect ratio. The results indicate that variations in roll diameter (1400, 1300, and 1200 mm) influence crack propagation, with cracks unfolding earlier when the roll diameter is 1400 mm. At varying initial rolling temperatures (1300, 1200, and 1100 °C), cracks begin to unfold earlier at the highest temperature of 1300 °C. When examining different friction coefficients (0.4, 0.5, and 0.6), cracks unfold earlier at the highest coefficient of 0.6. Similarly, at different rolling speeds (3, 4, and 5 m s−1), cracks unfolded earlier at the highest speed of 5 m s−1. Analysis of changes in crack depth and aspect ratio during rolling shows that the initial few passes have a greater influence on crack depth and unfolding. In the later stages of rolling, cracks continue to unfold, though the depth shows minimal variation, and the aspect ratio tends to approach zero.

Ratcheting short crack behavior in medium carbon bainitic back-up roll steel under mild tractive rolling contact

Vertical Short Crack Initiation in Medium Carbon Bainitic Steel Under Mild Tractive Rolling Contact

Ratcheting led surface failure of medium carbon bainitic steel under mild operation conditions

Optimization of Preventive Grinding of Backup Roll Against Contact Fatigue Cracking

Vertical short-crack behavior and its application in rolling contact fatigue

BEHAVIOR OF SHORT FATIGUE CRACKS IN MEDIUM CARBON BAINITIC BACK-UP ROLL STEEL UNDER MILD TRACTIVE ROLLING CONTACT

Failure Analysis on Vertical Cracking of Medium Carbon Bainitic Steel Backup Roll

Rolling Contact Fatigue Crack Initiation in Medium Carbon Bainitic Steel

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Finite Element Analysis of Contact Stresses on the Backup Roll of CVC Hot Rolling Mills

Extended crack propagation in nitrided and carburised steels subject to rolling contact fatigue

Subsurface propagation of partial ring cracks under rolling contact: Part I. Experimental studies

Rolling Contact Fatigue Failure Mechanism of Martensitic Bearing Steel after Carbonitriding

Fatigue and recrystallization evolution of carbide-free bainitic layer under high-stress rolling sliding contact

Rolling contact fatigue failure mechanism of bearing steel on different surface roughness levels under heavy load

A study of local microstructure decay in GCr15 due to rolling contact

Influence mechanism of grinding surface quality of 20CrMnTi steel on contact failure

Experimental Study on the Influence of Surface Carbon Content on Crack Initiation for 20Cr2Ni4A Steel

Effect of Rolling Process Parameters on Transverse Cracks on the Surface of Q345 Steel

Subsurface propagation of partial ring cracks under rolling contactPart II. Fracture mechanics analysis

Towards understanding the crack suppression mechanism in brittle materials with high grinding speed at different temperatures