Abstract:A control strategy of flow reversal with hot gas withdrawal for heat recovery was developed and verified for the mitigation and utilization of ventilation air methane (VAM) in a reverse flow reactor. The flow reversal strategy was based on the thermal front propagation velocity and a logic-based controller was built to avoid catalyst deactivation and reaction extinction caused by prolonged rich or lean feed conditions; the utilization of heat released from VAM combustion was considered through heat extraction by withdrawing part of hot gas from the middle of the reactor. By means of simulation using a one-dimensional heterogeneous model, the results revealed that the flow direction should be reversed before the temperature peak passing through the middle of the reactor to reduce the discharge of unreacted methane as well as to enhance the heat recovery efficiency; a fixed (relatively short) switching time is reasonable for the reactor operation in the case of hot gas withdrawal. The stability and autothermicity of reverse flow reactor are jointly influenced by the feed concentration and hot gas withdrawal fraction; the reactor can only be run stably in a narrow operating window (stability area). Heat recovery and bed temperature regulation are achieved mainly by hot gas withdrawal, while air dilution and extra methane injection are the auxiliary manipulated variables to sustain the reaction in some extreme circumstances. An extra catalyst bed along the way to the boiler is effective to enhance the overall methane conversion by oxidizing the unreacted methane. A case study under modified real ventilation conditions shows that the control strategy developed in this work is feasible to mitigate and utilize VAM if the methane content is higher than 0.2vol.%.

Modelling and simulation for adiabatic fixed-bed reactor with flow reversal

The two-dimensional heterogeneous modeling for non-isothermal non-adiabatic fixed-bed reactor and the analysis by orthogonal collocation

Modeling and Simulation of Commercial Catalytic Reformers

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

Numerical Simulation of Cross Flow in Fixed Bed Reactor

Numerical Simulation Approach for a Dynamically Operated Sorption-Enhanced Water-Gas Shift Reactor

Integrated Gas and Solid Model to Determine the Flow Performance in the SCR Reactor

Simulation and Analysis of Fixed-Bed Reactor for Hydrochlorination of Acetylene

Analysis of configurational factors that influence the reversibility of nonstoichiometric countercurrent thermal reduction reactors

Response of reverse flow reactor to periodic inlet concentration varaition

Modeling and Simulation of Chemically Reacting Flows in Gas-Solid Catalytic and Non-Catalytic Processes

Semi-Analytical Solution of a Nonlinear Heat Transfer Model for a Tubular Cocurrent Moving-Bed Reactor With a First-Order Chemical Reaction in the Solid Phase

3D Eulerian-Eulerian modeling of a screw reactor for biomass thermochemical conversion. Part 1: Solids flow dynamics and back-mixing

Effect of Periodic Variation of the Inlet Concentration on the Performance of Reverse Flow Reactors

Simulation of the gas distribution system for a radial flow moving-bed catalytic reforming reactor in change state flow

Reactive direct simulation Monte Carlo modeling of gas reactive transport in three dimensional porous fibrous media across rarefied to continuum regimes

A control strategy of flow reversal with hot gas withdrawal for heat recovery and its application in mitigation and utilization of ventilation air methane in a reverse flow reactor

The Real-Time Dynamic Modeling and Simulation of Reforming Moving-Bed Reactor

The design of heterogeneous simulation reactor based on Fluent

A moving-boundary model of reactive settling in wastewater treatment. Part 2: Numerical scheme

Modelling and Optimisation of Distributed-Parameter Batch and Semi-Batch Reactor Systems