Abstract:A wide-band online partial discharge(PD)detection method is discussed to minimize the influence of the noise and interferences during the course of measurement and diagnosis followed.The traditional IEC pulse current detection method and the recently developed ultra high frequency detection method have limited their bandwidth to avoid the abundant ambient noise and interference,and loss of the information of the PD signals as well.The methods can not record the entire discharge waveforms of the PD current pulses,causing a fundamental lack of information to neither differentiate various signals and noises,nor distinguish various PD or interference patterns.The wide band detection method covers a bandwidth wide enough to record the entire partial discharge pulse waveforms.Based on the features of their pulse waveforms,such signals can be separated and recognized in a'clean'condition.An experiment employing such method on a 110kV cable with several discharge patterns and onsite noises is presented.The analysis shows that,with sufficient information of the entire waveform,those discharge patterns can be separated,and each of the'clean and pure'sub-patterns,such as the internal discharge and background noises can be isolated and well recognized.For field PD detection and diagnosis,the method would increase the ability to remove the impact of onsite noises and interferences,as well as the ability to diagnose the insulation condition based on the PD information.

Study on Partial Discharge Online Monitoring System Mounted at Neutral Point for Electric Generators

Online Damping Monitoring Approach Based on Disturbances of Traction Load and Its Application

On-line Partial Discharge Monitoring and Diagnostic System

A COMPUTER DISTRIBUTED PD MONITORING SYSTEM FOR 330kv GIS

Partial Discharge Diagnosis for Transformer - One Step Toward Strong Smart Grid in China

Noise Rejection Techniques Used for On-Line Monitoring of Partial Discharges in Large Turbine Generators

Noise suppressing techniques used for on-line monitoring of partial discharge in large generators

Partial discharge theory and technologies related to medium-voltage electrical equipment

RESEARCH AND DEVELOPMENT OF ON-LINE MONITORING SYSTEM WITH PARTIAL DISCHARGE IN XLPE POWER CABLES

DEVELOPMENT OF ON-LINE MONITORING SYSTEM FOR PARTIAL DISCHARGE WITHIN POWER TRANSFORMER

FUNDAMENTAL STUDIES AND APPLICATIONS ON DISCHARGE FAULTS DIAGNOSIS OF GENERATORS AND TRANSFORMERS

Detection and Identification Technologies of Wide Band Partial Discharge

APPROACHES OF ON-LINE MONITORING FOR HV ELECTRICAL MACHNES PARTIAL DISCHARGE

Efficient and Low-Cost PD Monitoring and Locating System for MV Switchgears Using TEV Detectors

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Review on Detection and Analysis of Partial Discharge along Power Cables

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

Power Distribution Network Ground Fault Location Algorithm Using On-Line Detectors

Development of Intelligent Monitoring System for Surge Protective Devices

Development and Application of DC Partial Discharge Test System