Abstract:The reactive current can be reduced effectively by decreasing the frequency of the voltage in partial discharge (PD) test, especially for equipment with large capacitance. Thus, the cost and volume of the test power supply can be economized. To figure out the difference of PD characteristics in transformer oil between rated alternating-current (AC) frequency (50 Hz) and low frequency, tests are conducted from rated AC frequency to very low frequency (0.1 Hz) based on impulse current method. The results show that with the decrease of frequency, the inception voltage increases. The maximum and mean magnitude of discharge and pulse repetition rate first increase slightly, then decrease obviously. The main features of the variation of phase resolved PD (PRPD) patterns, discharge statistical patterns (phase distribution of maximum and mean discharge magnitude, pulse repetition rate q(max)-phi, q(mean)-phi, n-phi; and number distribution of discharge magnitude n-q), and their characteristic parameters (skewness S-k(+), S-k(-); kurtosis K-u(+), K-u(-); asymmetry A(sy); and correlation coefficient C-c) are depicted in detail, which should be paid attention to when using low frequency voltage. The inner mechanism for these variations is discussed from the aspects of the influence on electric field distribution and discharge process of frequency. Additionally, the variation trend of PD characteristics with the decrease of frequency can provide more information about insulation defect, which can be the supplement for discharge mode recognition.

Partial Discharge Diagnosis for Transformer - One Step Toward Strong Smart Grid in China

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Identification of Partial Discharge Based on Composite Optical Detection and Transformer-Based Deep Learning Model

Detection and Identification Technologies of Wide Band Partial Discharge

Recognition of Transformer High Frequency Partial Discharge Based on Time Domain Feature

On-line Partial Discharge Monitoring and Diagnostic System

Locating Partial Discharge in Power Transformer by Electrical Method

Comparison of Pd Detection Methods for Power Transformers - Their Sensitivity and Characteristics in Time and Frequency Domain

Partial discharge theory and technologies related to medium-voltage electrical equipment

Partial Discharge Fault Diagnosis in Power Transformers Based on SGMD Approximate Entropy and Optimized BILSTM

Partial Discharge Characteristics in Oil-Paper Insulation under Combined Ac-Dc Voltage

Study on the Influence of Pulse Propagation in Transformer Winding on Partial Discharge Pattern Recognition

Feature Extraction And Comprehension Of Partial Discharge Characteristics In Transformer Oil From Rated Ac Frequency To Very Low Frequency

Review on Detection and Analysis of Partial Discharge along Power Cables

FUNDAMENTAL STUDIES AND APPLICATIONS ON DISCHARGE FAULTS DIAGNOSIS OF GENERATORS AND TRANSFORMERS

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

Partial Discharge Diagnostics: Data Cleaning and Feature Extraction

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

Study on pulse current of typical PD models in power transformer

Quantitative analysis and evaluation of the optimization method of transformer partial discharge ultrasonic sensor monitoring

Research on the Ground Wire Sensing Method for On-line Partial Discharge Detection of Transformers