Abstract:The power transformer is one of the most critical core devices for energy exchange in power systems, and its safe and stable operation is directly related to the reliability of the power grid. Partial discharge is the main cause of insulation degradation and failure of high-voltage electrical equipment. Online monitoring and accurate localization of partial discharge can provide information on the aging of power equipment, which is of great value for improving the safe operation and maintenance of the power grid. Internal dual partial discharge in transformer windings is a more complex type of fault. Since it is located inside the windings, the signal is attenuated and distorted, making it difficult for traditional monitoring methods to capture such partial discharge signal The Fabry–Perot optical fiber sensor is an ultrasonic detection method that can be built into the transformer interior. This sensor has high sensitivity and a small size, enabling flexible placement at different locations inside the transformer for precise partial discharge detection. Especially for the narrow space inside the high and low voltage windings, F–P sensors can form an array, utilizing the array's directivity to locate the fault points. In this study, an ultrasonic detection system based on the F–P optical fiber sensor array was developed. The system utilizes a directional cross-localization algorithm based on the multiple signal classification (MUSIC) algorithm to accurately locate dual partial discharge sources. This partial discharge detection system was applied to a 35 kV single-phase transformer, enabling the localization of dual partial discharge sources within the high and low voltage windings. Combined with experimental results, this method exhibits high localization accuracy and is particularly suitable for detecting partial discharge phenomena that occur within or between transformer windings.

APPROACHES OF ON-LINE MONITORING FOR HV ELECTRICAL MACHNES PARTIAL DISCHARGE

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

On-line Partial Discharge Monitoring and Diagnostic System

Partial discharge theory and technologies related to medium-voltage electrical equipment

METHODS OF NOISE SUPPRESSION FOR ON-LINE MONITORING PARTIAL DISCHARGE IN TRANSFORMERS

DEVELOPMENT OF ON-LINE MONITORING SYSTEM FOR PARTIAL DISCHARGE WITHIN POWER TRANSFORMER

An Online Monitoring Technique for Partial Demagnetization Monitoring of Permanent Magnet Machines Based on Intermittent Short-circuit

Uneven Demagnetization Fault Diagnosis in Dual Three-Phase Permanent Magnet Machines Based on Electrical Signal Difference

RESEARCH AND DEVELOPMENT OF ON-LINE MONITORING SYSTEM WITH PARTIAL DISCHARGE IN XLPE POWER CABLES

Assessment of stages of partial discharge process of typical oil-paper insulation defect under combined AC-DC voltage

Noise Rejection Techniques Used for On-Line Monitoring of Partial Discharges in Large Turbine Generators

Detection and Identification Technologies of Wide Band Partial Discharge

An Experimental Study on the Partial Discharge Model in Stator Windings Insulation of Generators

Research on the Ground Wire Sensing Method for On-line Partial Discharge Detection of Transformers

Diagnosis of Insulation Condition of MV Switchgears by Application of Different Partial Discharge Measuring Methods and Sensors

Quasi-Online Technique for Health Monitoring of Stator Winding Insulation in Inverter-Fed Motor Using Switching Transient Voltage Response

Application of HFCT and UHF Sensors in On-Line Partial Discharge Measurements for Insulation Diagnosis of High Voltage Equipment

Partial Discharge Diagnosis for Transformer - One Step Toward Strong Smart Grid in China

Localization of Dual Partial Discharge in Transformer Windings Using Fabry–Pérot Optical Fiber Sensor Array

Comparison of on-line partial discharge detection methods for HV cable joints

The Application of Partial Discharge Detection for the Condition Assessment of Xlpe Power Cables