Abstract:The effects of substrate temperature and O-2 flux on structural, electrical, and optical properties of the films prepared by RF reactive magnetron sputtering with SnF2-Sn target have been investigated by X-ray diffraction (XRD), Hall effect measurements, optical transmission spectra, and photoluminescence (PL) spectra. It is found that F-doped SnO films are produced and exhibit amorphous structure at lower O-2 fluxes for substrate temperature of RT-300 degrees C, and window of O2 flux for depositing the films is reduced as substrate temperature increases. F-doped SnO2 (FTO) films are formed at higher O-2 fluxes, and they exhibit amorphous state at substrate temperature of RT but crystalline state at substrate temperature of 150 and 300 degrees C. Furthermore, increasing O-2 flux or substrate temperature can promote crystallinity and affect growth orientation for crystalline FTO films. Highly conductive FTO films can be obtained only at suitable O-2 fluxes and higher substrate temperatures (150 and 300 degrees C), at which the films keep crystalline SnO2 structure along with high amount of oxygen vacancy (V-O). Increasing substrate temperature from 150 to 300 degrees C, the resistivity of FTO films cannot be further decreased due to the out-diffusion of F although the film crystallinity improves. Compared with F-doped SnO films, the average transmittance in visible light range and band gap (E-g) of FTO films obviously increase. The FTO films show similar shaped PL spectra that can be attributed to substitutional fluorine (F-O) and V-O defects in the films, and PL emission intensity increases with increasing O-2 flux or substrate temperature due to the improvement of film crystallinity. It is observed that the PL emission characteristics (shape and intensity) of F-doped SnO film are obviously different from FTO films and they have great changes as substrate temperature from RT to 150 degrees C, but corresponding mechanisms need to further clarify. (C) 2017 Elsevier B.V. All rights reserved.

Fabrication and characterization of indium-doped p-type SnO2 thin films

Transparent P-Type Conducting Indium-Doped SnO2 Thin Films Deposited by Spray Pyrolysis

P-Type Transparent Conducting Indium-Tin Oxide Thin Films Deposited By Spray-Pyrolysis

P-type Tin–indium Oxide Films Prepared by Thermal Oxidation of Metallic InSn Alloy Films

Surface Pattern and Optical Properties of In-doped ZnO Thin Films by Hydrothermal Method

Magnetron-Sputtered SnO Thin Films for p-Type and Ambipolar TFT Applications

Transparent conductive F-doped SnO 2 films prepared by RF reactive magnetron sputtering at low substrate temperature

P-Type ZnO Thin Films Fabricated by Dc Magnetron Reactive Sputtering Method at Different Substrate Temperatures

Structural, Electrical, and Optical Properties of F-doped SnO or SnO2 Films Prepared by RF Reactive Magnetron Sputtering at Different Substrate Temperatures and O2 Fluxes

P-Type Behavior in In–N Codoped ZnO Thin Films

Control and Improvement of P-Type Conductivity in Indium and Nitrogen Codoped Zno Thin Films

OPTICAL AND ELECTRICAL PROPERTIES OF SnO2:Sb THIN FILMS DEPOSITED BY SOL-GEL PROCESS

Conversion of p-type SnO to n-type SnO 2 via oxidation and the band offset and rectification of an all-Tin oxide p-n junction structure

Preparation and characterization of SnO films via reactive sputtering for ambipolar thin-film transistor applications

Solution-processed amorphous p-type Cu-Sn-I thin films for transparent Cu-Sn-I/IGZO p–n junctions

Plasma-enhanced atomic layer deposition of Sn-doped indium oxide semiconductor nano-films for thin-film transistors

Interstitial doping of SnO 2 film with Li for indium-free transparent conductor

Investigation of In2O3:SnO2 films with different doping ratio and application as transparent conducting electrode in silicon heterojunction solar cell

Effects of the Variations of Oxide Structure on the Electrical and Optical Properties of ITO Films

Compositional changes between metastable SnO and stable SnO 2 in a sputtered film for p-type thin-film transistors