Abstract:PST thin film doped with Mg was successfully prepared using sol-gel process. The phase structure of the thin film was measured by XRD and the morphology of microstructure of the thin film was observed by SEM. Results showed that the cubic perovskite phase is formed in Mg-doped Pb 0.4 Sr 0.6 Mg x Ti 1-x O 3-x thin film prepared by sol gel process. The clustered crystallites are distributed and embedded in the base matrix of thin f ilm. However, the contents of the perovskite phase was controlled by both Mg dop ing and heat treatment condition due to formation of intrinsic oxygen vacancy in the perovskite phase. The charge balance between the positive from the intrinsi c oxygen vacancy and the negative from Mg substitution for Ti occurs when small amount of Mg is doped in the perovskite phase. The stable perovskite phase forms easily, and the crystallization of the perovskite phase is hence increased with increasing Mg doping up to x=0.01. The distortion of the perovskite phase struc ture would increase with farther increase of Mg doping in the crystallites above about x=0.01 due to the generation of a lot of oxygen vacancies. Henceforth uns table perovskite phase is formed and the crystallization of the film decreases w ith increasing Mg. Thus highest content of the perovskite phase is reached and t he charge balance between positive and negative occurs in the film when Mg dopin g is x=0.01. Furthermore, the formed crystalline phase may decompose with increa sing Mg content and time of heat treatment. So in the case of high Mg doping the higher the content of Mg and the longer the time of heat treatment, the lower t he content of perovskite phase is contained in the film.

Limits of Formation of Random Grown Perovskite and Pyrochlore Phases in Sol–gel Derived La Modified Lead Zirconate Titanate Thin Films

Synthesis of LaCrO3 films using spray pyrolysis technique

Preparation of PZT Thick Film by a High Speed Sol-gel Method

Growth Mode of Sol-Gel Derived PLT Seeding Layers on Glass Substrates and Its Effect on Templating the Oriented Growth of PLZT Thin Films

Formation of thin films by sol-gel processing

Interface and Surface Characterization of Lead Zirconate Titanate Thin Films Grown by Sol–Gel Method

Electric-Induced Deposition of Lead Zirconate Titanate Porous Monolayer Film

Epitaxial Plt Thin Films Prepared by A Sol-Gel Process

Thickness-dependent structural characteristics of sol–gel-derived epitaxial (PbZr)TiO3 films using inorganic zirconium salt

Surface layers of the sol-gel derived PbTiO3 thin films

STRUCTURE AND DIELECTRIC PROPERTIES OFLa-DOPED LEAD STRONTIUM TITANATE THIN FILMS DERIVED FROM SOL–GEL METHOD

Preparation and Phase Formation of Sol-Gel Derived PST Thin Film Doped with Mg

Effect of pyrolysis temperature on preferential orientation and electrical properties of sol-gel derived lead zirconate titanate films

Sol–gel synthesis and characterization of PZT thin films on FTO/aluminoborosilicate glass substrates

Preparation and Crystallization of Pb(Zr0.95Ti0.05)O3 Thin Films Deposited by Radio-Frequency Magnetron Sputtering with a Stoichiometric Ceramic Target

Structure and Dielectric Properties of Highly (100)-Oriented PST Thin Films Deposited on MgO Substrates

Substrate effect on the PLD growth of ferroelectric materials thin films

Preparation on the [(Pb,La) (Zr,Ti)O3] ferroelectric thin films by using the Sol-Gel processing

The Structures and Dielectric Properties of Ba0.80Sr0.20TiO3/Pb0.82La0.18TiO3 Composite Thick Films with Addition of PbO–B2O3 Glass

Crystallization features and physical properties of the thin-film heterostructure of lead zirconate titanate – lead oxide

Structural and Morphological Studies of Pt in the As-Grown and Encapsulated States and Dependency on Film Thickness