Abstract:We designed a dual‐embedded flat heat pipe heat sink for heat dissipation at the hot side of the thermoelectric cooler (TEC) to improve the working performance of the TEC. Through a combination of experimental and numerical simulations, we compared them with ordinary aluminum heat sinks and examined the effects of heat dissipation conditions and heat pipe geometry on TEC and heat sink performance. The results show that the performance of the aluminum heat sink can be improved, and the working efficiency of the TEC can be improved through this design. As for improving the heat diversion capacity of the hot side heat sink of the thermoelectric cooler (TEC), thereby improving the operational performance of the TEC, this study designed a type of double‐embedded flat heat pipe (EFHP) finned heat sink and compared with a standard aluminum (Al) heat sink. In experimental studies, TEC under two heat sinks were placed under different operating currents for heat transfer analysis and performance comparison. The experimental results demonstrated that the EFHP heat sink had better heat diversion ability, effectively improving the operational performance of TEC. When the TEC was input with a current of 6A, the thermal resistance of the double EFHP finned heat sink decreased by 19% compared to the Al heat sink; cooling capacity and coefficient of performance increased by 8.3% and 9.46%, respectively. Further, TEC's cold and hot surface temperatures decreased by 10.83% and 10.2%, respectively, and the heat uniformity of the heat sink improved. In addition, the CFD software Icepak was used to analyze the effects of double flat heat pipe spacing and length on the heat sink and TEC and the performance of two heat sinks and TEC under different heat dissipation conditions and obtained good agreement. This study can provide further guidance and assistance in designing the TEC cooling system.

Optimization design of structure of TEC temperature control system for microfluidic PCR

FEA for Steady-State Thermal Performance of PCR Thermal-Cycler Based on Thermoelectric Cooler

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Study on factors affecting thermal performance of PCR thermal cycle system by equivalent circuit

FEA simulation research of temperature uniformity in quantitive PCR thermal cycle system

Research on thermal cycle system for real-time PCR instrument based on equivalent circuit model

Research on temperature measuring positions selection and verification for Polymerase Chain Reaction instruments.

Modeling and Analysis of Thermal Cycle System for Quantitative PCR Instrument

Simulation and experimental study of temprature lag time for Polymerase Chain Reaction instrument

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

A Thermal Cycler Based on Magnetic Induction Heating and Anti-Freezing Water Cooling for Rapid PCR

Study on a Low Power and High Efficiency Micro Heater Used in Μpcr Chip

Simulation of Rapid Thermal Cycle for Ultra-Fast PCR

Design and performance analysis of hot side heat sink of thermoelectric cooler device based on simulation and experiment

Study on Micro PCR System and Its Temperature Control Property

Implementation of Rapid Nucleic Acid Amplification Based on the Super Large Thermoelectric Cooler Rapid Temperature Rise and Fall Heating Module

Open Thermal Control System for Stable Polymerase Chain Reaction on a Digital Microfluidic Chip

Structural optimization and algorithm design for temperature control system of mid-infrared diode laser

Thermal Design of PCR Chip Based on Natural Convection in a Micro Chamber

Temperature control technology for PCR

Control Design of Surface Temperature Adaptive Material System