Abstract:The irreversibility of the thermoelectric cooling (TEC) model could analyze and optimize refrigeration performance. In present work, a one-dimensional thermal conductivity model of the internal irreversible thermoelectric element was first established. Subsequently, two categories of evaluation indexes were further analyzed, i.e., cooling capacity Q c and coefficient of performance (COP). The thermodynamic model of TEC was then established jointly with finite time thermodynamics. The influences of current and the ratio of heat transfer areas between cold and hot sides on the steady-state characteristics of TEC were further discussed under Newtonian linear heat transfer. In addition, a transient thermodynamic model of TEC equipment was built to compare the effects of pulse width, pulse gradient, and pulse current on the cold side temperature of the TEC module. Theoretical results demonstrated that the effective working range of the steady-state operating current is 2A ≤ I ≤ 25A, and the area ratio of heat transfer between cold and hot sides is 0.07 ≤ x ≤ 1. The cooling capacity ( Q c ) and coefficient of performance (COP) could reach up to about 50W and 2.0, respectively. In addition, the increase of external heat transfer capacity of the hot side could reduce the transient supercooling temperature and the peak overshoot temperature, simultaneously. Afterward, the cooling capacity was remarkably enhanced. Current research could provide a reliable support for the optimization design and performance improvement of the thermoelectric cooler. Thermal conductivity model of internal irreversible thermoelectric element was established; Effects of cold and hot ends on the TEC were discussed under Newtonian linear heat transfer; Effects of pulse width, gradient and current on TEC cold end temperature were investigated; Heat transfer capacity of TEC hot end could reduce supercooling and overshoot temperatures; The irreversibility of TEC model will enhance its potentials for low grade energy exploitation.

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

Optimization of heat sink of thermoelectric cooler using entropy generation analysis

Analysis on optimal heat exchanger size of thermoelectric cooler for electronic cooling applications

Thermodynamic optimization analysis of a tube-in-tube helically coiled heat exchanger for Joule-Thomson refrigerators

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Experimental Study and Taguchi Analysis on LED Cooling by Thermoelectric Cooler Integrated with Microchannel Heat Sink

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Multi-parameters Analysis and Optimization of a Typical Thermoelectric Cooler Based on the Dimensional Analysis and Experimental Validation

Real-time optimization of thermoelectric coolers' performance based on energy and exergy analysis

Performance optimization of a class of combined thermoelectric heating devices

Optimum allocation of heat transfer surface area for cooling load and COP optimization of a thermoelectric refrigerator

Performance enhancement of a novel thermoelectric self-cooling system for electronic devices

Irreversibility of thermoelectric cooling model: Newtonian linear heat transfer and finite time thermodynamics

Numerical Study and Optimization of a Combined Thermoelectric Assisted Indirect Evaporative Cooling System

Thermal management of a flexible controlled thermoelectric energy conversion-utilization system using a multi-objective optimization

Thermodynamic Analysis of TEG-TEC Device Including Influence of Thomson Effect

Optimizing the Geometric Structure of a Thermoelectric Cooler with Multi-objective Constraint

Cost-Performance Trade-off in Thermoelectric Air Conditioning System with Graded and Constant Material Properties

Enhancing the cooling performance of thermocouples: a power-constrained topology optimization procedure

Evaluation on the Applicability of Thermoelectric Air Cooling Systems for Buildings with Thermoelectric Material Optimization

Optimizing a thermoelectric window frame for heating and cooling: A cross-validated simulation study