Abstract:Heat exchangers play a major role in reducing emissions and conserving energy. There is a plethora of theoretical research on the enhancement of heat transfer caused by ionic wind, but there is still a lack of studies on the practical application of ionic wind in heat exchangers to increase heat exchange capacity. This work developed an original ionic wind heat exchanger with a dividing wall. It may be applied to difficult circumstances when conventional heat exchangers fail for air-to-air heat exchange. The study conducted experiments to investigate the impact of many factors, including intake air velocity, discharge spacing, and electrode distribution scheme, on the ionic wind intensity and the heat exchanger's increased heat transfer coefficient. A two-dimensional model was used to analyze the internal flow and thermal properties of the heat exchangers with wire emitters. By combining active and passive heat exchange technologies, an ionic wind heat exchanger with serrated grounded electrodes was presented. The outcomes demonstrated that a suitable intake air velocity enhances the heat exchanger's capacity for heat exchange. The improved heat exchange effect of ionic wind is more important when the inlet wind speed is less than 1 m/s. When the intake air velocity approaches 1.3 m/s, the ionic wind has less of an impact on the heat exchanger's capacity for heat exchange. The benefits of improved heat transfer are promoted by placing the emitter closer to the channel entry. Increasing the operating voltage further enhances the heat transfer enhancement ratio (HTER). The number and arrangement of wire electrodes should be chosen with consideration for the 'barrier effect' between neighboring emitters and the distance from the entrance when utilizing multiple wire electrodes. In comparison to the three-wire and five-wire electrodes, the four-wire electrode heat exchanger's HTER values were increased by 5.9 % and 14.3 %, respectively. The ionic wind heat exchanger's capacity for heat transfer is further increased using a zigzag grounding electrode. The zigzag uses a decreased aspect ratio, and the emitter is positioned slightly above the tip, improving the system's heat transfer capabilities. When compared to a heat exchanger with a flat plate grounded electrode, the four-wire electrode heat exchanger produced a 158 % increase in HTER value.

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Study on the Performance of a Solid-State Thermoelectric Refrigeration System Equipped with Ionic Wind Fans for Ultra-Quiet Operation

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

Nature Convection Heatsink Modeling and Optimization Based on Nusselt Number Correlation

Numerical Study on Heat and Ion Transport Characteristics Enables Optimal Design of Aqueous Thermocells for Low-Grade Heat Recovery

Heat transfer performance and electrohydrodynamic characteristics optimization of a dividing-wall-type ionic wind heat exchanger

Numerical study of flow and heat transfer on construction machinery detached vehicular cooling system

Numerical Study and Optimization of a Combined Thermoelectric Assisted Indirect Evaporative Cooling System

Test for Thermoelectric Self Cooling

Numerical Simulation of a Thermosyphon Radiator Used in Electronic Devices

Optimal Flow Layout and Current Allocation for Improving the Thermoelectric Refrigeration System Based on Heat Current Method

Multi-parameters Analysis and Optimization of a Typical Thermoelectric Cooler Based on the Dimensional Analysis and Experimental Validation

Assessment and validation of a numerical model for phase change materials heatsink on thermoelectric devices

Numerical simulation and experiment for thermal behavior of stratospheric electronic equipment

Performance Analysis of a Novel Thermoelectric-Based Battery Thermal Management System

Magnetic field enhanced ionic wind for environment-friendly improvement and thermal management application

Numerical Simulation on Heat and Mass Transfer of Plate Evaporative Condenser

Numerical investigation of a battery thermal management system integrated with vapor chamber and thermoelectric refrigeration

Evaluation on the Applicability of Thermoelectric Air Cooling Systems for Buildings with Thermoelectric Material Optimization

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered