Abstract:Localized boiling and enclosed condensation of a dielectric liquid in a thermosyphon can be used as an alternative to traditional air cooling for high performance microprocessors. A small quantity of dielectric fluid boils at the surface of the microprocessor and is condensed by a heat exchanger, which removes the heat from the system. Here, the heat exchanger was a water-fed cold plate cooling a round fins heat sink. Such a thermosyphon can remove large heat fluxes and increase the energy efficiency of data centers. An experimental setup was built to measure the impact of various operating parameters on the thermal resistances of the thermosyphon. The thermal resistances that were considered were the boiling resistance between the heater and the dielectric fluid, the condensation resistance between the dielectric fluid and the cold water feeding the cold plate, and their sum (the total thermal resistance). The operating parameters tested were the cold plate inlet flow rate (0.2 L/min and 1 L/min), the cold plate inlet temperature (15°C and 24°C) and the filling ratio of the enclosure (33%, 66% and 88%). It was observed that changing the filling ratio did not have a significant impact on the thermal resistances of the thermosyphon. Increasing the cold plate inlet flow rate from 0.2 L/min to 1 L/min and decreasing the cold plate inlet temperature from 24°C to 15°C both led to significantly lower total thermal resistance. However, increasing the flow rate lowered the rate at which the pressure increased with the amount of heat removed from the system, while this rate did not change when decreasing the cold plate inlet temperature. These observations could be properly explained by a simple analytical model, with a single free parameter (increasing the thermal resistance of the heat sink for the lowest cold plate flow rates). With the free parameter adjusted to the data, the model had a root-mean square error of 1.8°C and a maximum error of 6°C, over all measured conditions. This study demonstrates how changing the filling ratio or the cold plate inlet temperature and flow rate have an impact on the pressure, the temperature and the thermal resistances inside the thermosyphon. This is a first step in evaluating the energetic and economic efficiency of the thermosyphon solution for its future integration in data centers.

Numerical Simulation of a Thermosyphon Radiator Used in Electronic Devices

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Experimental Study on Heat Transfer Characteristics of Thermosyphon Radiator

Heat transfer characteristics of two different thermosyphon radiators for electronic device

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Numerical Simulation Study on Thermal-Hydraulic Performances of Vehicular Radiator Heat Transfer Units

Numerical investigation of the thermal performance of a loop thermosyphon considering dynamic condensation mass transfer time relaxation parameter

Numerical Simulation and Experimental Verification on Thermal Performance of A Novel Fin-Plate Thermosyphon

Transient experimental and numerical study of thermosyphon under different heating fluxes and filling ratios

Numerical Simulation on Heat and Mass Transfer of Plate Evaporative Condenser

Experimental Study on Indirect Thermosyphon Radiator Coupled with Flat Heat Pipe for Electronic Component

Experimental Study on Thermosyphon Heat Sink for Cooling of Electronic Apparatus

Numerical Simulation on Subcooled Pool Boiling

Modelling and analysis of a liquid-cooled system for thermal management application of an electronic equipment

Assessment and validation of a numerical model for phase change materials heatsink on thermoelectric devices

Performance and regression analysis of air-cooled thermoelectric cooling system using response surface methodology and numerical simulation

Numerical simulation and experiment for thermal behavior of stratospheric electronic equipment

Experimental and numerical analysis of a nanofluidic thermosyphon heat exchanger

Numerical Simulations of a Micro-Channel Wall-Tube Condenser for Domestic Refrigerators

Thermal design of a novel heat sink cooled by natural convection with phase transition in the series loop

Condenser Operating Conditions Effects on Dielectric Liquid Boiling and Condensation Heat Transfer in Closed Systems