Abstract:Polymerase chain reaction (PCR) is the most common method used for nucleic acid (DNA) amplification. The development of PCR-performing microfluidic reactors (μPCRs) has been of major importance, due to their crucial role in pathogen detection applications in medical diagnostics. Closed loop (CL) is an advantageous type of μPCR, which uses a circular microchannel, thus allowing the DNA sample to pass consecutively through the different temperature zones, in order to accomplish a PCR cycle. CL μPCR offers the main advantages of the traditional continuous-flow μPCR, eliminating at the same time most of the disadvantages associated with the long serpentine microchannel. In this work, the performance of three different CL μPCRs designed for fabrication on a printed circuit board (PCB) was evaluated by a computational study in terms of the residence time in each thermal zone. A 3D heat transfer model was used to calculate the temperature distribution in the microreactor, and the residence times were extracted by this distribution. The results of the computational study suggest that for the best-performing microreactor design, a PCR of 30 cycles can be achieved in less than 3 min. Subsequently, a PCB chip was fabricated based on the design that performed best in the computational study. PCB constitutes a great substrate as it allows for integrated microheaters inside the chip, permitting at the same time low-cost, reliable, reproducible, and mass-amenable fabrication. The fabricated chip, which, at the time of this writing, is the first CL μPCR chip fabricated on a PCB, was tested by measuring the temperatures on its surface with a thermal camera. These results were then compared with the ones of the computational study, in order to evaluate the reliability of the latter. The comparison of the calculated temperatures with the measured values verifies the accuracy of the developed model of the microreactor. As a result of that, a total power consumption of 1.521 W was experimentally measured, only ~7.3% larger than the one calculated (1.417 W). Full validation of the realized CL μPCR chip will be demonstrated in future work.

Open Thermal Control System for Stable Polymerase Chain Reaction on a Digital Microfluidic Chip

Adaptive Fuzzy Pid Control For Polymerase Chain Reactions

FEA for Steady-State Thermal Performance of PCR Thermal-Cycler Based on Thermoelectric Cooler

Simulation and experimental study of temprature lag time for Polymerase Chain Reaction instrument

Research on thermal cycle system for real-time PCR instrument based on equivalent circuit model

Study on factors affecting thermal performance of PCR thermal cycle system by equivalent circuit

Temperature control technology for PCR

A Microchip-Based PCR Device Using Flexible Printed Circuit Technology

A Thermal Cycler Based on Magnetic Induction Heating and Anti-Freezing Water Cooling for Rapid PCR

Implementation of Rapid Nucleic Acid Amplification Based on the Super Large Thermoelectric Cooler Rapid Temperature Rise and Fall Heating Module

Simulation analysis and experimental verification of thermodynamic characteristics of integrated droplet digital PCR chip

Study on Micro PCR System and Its Temperature Control Property

Temperature Control System for Biochemical Reactions in Microchip-Based Devices

Implementation of the Inverse Problem for On-chip PCR Diagnostics with Rapid and Precise Thermal Cycling

Simulation of Rapid Thermal Cycle for Ultra-Fast PCR

Portable Heating System Based on a Liquid Metal Bath for Rapid PCR.

Droplet Based Micro Oscillating Flow-Through PCR Chip

A Thermocycler Using a Chip Resistor Heater and a Glass Microchip for a Portable and Rapid Microchip-Based PCR Device

A Thermal Cycler based on Solid-state Active Heat Pump and PID Control Algorithm toward Biomedical Applications

Closed-Loop Microreactor on PCB for Ultra-Fast DNA Amplification: Design and Thermal Validation

Thermal Design of PCR Chip Based on Natural Convection in a Micro Chamber