Abstract:Polymerase chain reaction (PCR) is the most common method used for nucleic acid (DNA) amplification. The development of PCR-performing microfluidic reactors (μPCRs) has been of major importance, due to their crucial role in pathogen detection applications in medical diagnostics. Closed loop (CL) is an advantageous type of μPCR, which uses a circular microchannel, thus allowing the DNA sample to pass consecutively through the different temperature zones, in order to accomplish a PCR cycle. CL μPCR offers the main advantages of the traditional continuous-flow μPCR, eliminating at the same time most of the disadvantages associated with the long serpentine microchannel. In this work, the performance of three different CL μPCRs designed for fabrication on a printed circuit board (PCB) was evaluated by a computational study in terms of the residence time in each thermal zone. A 3D heat transfer model was used to calculate the temperature distribution in the microreactor, and the residence times were extracted by this distribution. The results of the computational study suggest that for the best-performing microreactor design, a PCR of 30 cycles can be achieved in less than 3 min. Subsequently, a PCB chip was fabricated based on the design that performed best in the computational study. PCB constitutes a great substrate as it allows for integrated microheaters inside the chip, permitting at the same time low-cost, reliable, reproducible, and mass-amenable fabrication. The fabricated chip, which, at the time of this writing, is the first CL μPCR chip fabricated on a PCB, was tested by measuring the temperatures on its surface with a thermal camera. These results were then compared with the ones of the computational study, in order to evaluate the reliability of the latter. The comparison of the calculated temperatures with the measured values verifies the accuracy of the developed model of the microreactor. As a result of that, a total power consumption of 1.521 W was experimentally measured, only ~7.3% larger than the one calculated (1.417 W). Full validation of the realized CL μPCR chip will be demonstrated in future work.

Thermal Design of PCR Chip Based on Natural Convection in a Micro Chamber

FEA for Steady-State Thermal Performance of PCR Thermal-Cycler Based on Thermoelectric Cooler

Study on factors affecting thermal performance of PCR thermal cycle system by equivalent circuit

Research and verification of thermal model for PCR instrument temperature field

Research on thermal cycle system for real-time PCR instrument based on equivalent circuit model

Simulation and experimental study of temprature lag time for Polymerase Chain Reaction instrument

Research on temperature measuring positions selection and verification for Polymerase Chain Reaction instruments.

Numerical Simulation of Micro Flow-Through Pcr Chip

Analysis Of Thermal Cycling In Micro-Pcr Chip

Simulation analysis and experimental verification of thermodynamic characteristics of integrated droplet digital PCR chip

Study on Characterization of Micro Heater Used for Micro PCR Chip

Simulation of Rapid Thermal Cycle for Ultra-Fast PCR

Study on a Low Power and High Efficiency Micro Heater Used in Μpcr Chip

A Microchip-Based PCR Device Using Flexible Printed Circuit Technology

A Thermal Cycler Based on Magnetic Induction Heating and Anti-Freezing Water Cooling for Rapid PCR

A Thermocycler Using a Chip Resistor Heater and a Glass Microchip for a Portable and Rapid Microchip-Based PCR Device

Open Thermal Control System for Stable Polymerase Chain Reaction on a Digital Microfluidic Chip

Droplet Based Micro Oscillating Flow-Through PCR Chip

Kinetic Characteristics of Continuous Flow Polymerase Chain Reaction Chip: A Numerical Investigation

Closed-Loop Microreactor on PCB for Ultra-Fast DNA Amplification: Design and Thermal Validation

Temperature control technology for PCR