Abstract:Accurate measurement of CO2 generated from different emission sources is the basis for controlling CO2 emissions and mitigating global warming. With advantages of high accuracy and rapid response, isotope analyzers using spectroscopic techniques, particularly those using cavity ring-down spectroscopy, have been widely used for CO2 emissions monitoring. However, these analyzers often face challenges such as spectral interference from impurity gases and unstable temperature control within the optical cavity in isotope analyzers. To address these challenges, this paper proposes a low-temperature optical cavity scheme utilizing a split Stirling-type pulse tube cryocooler. Combining thermal boundary conditions with particle swarm optimization, a dynamic cooling and temperature control model of the optical cavity was established in MATLAB. The model subsequently analyzed the cooling process, temperature control, and stability of the optical cavity. After 120 h, the simulations showed that the central part of the optical cavity had cooled to 126.4 K with a heat leakage of 8.90 W, in agreement with the experimental results that stabilized at 126.8 K. The temperature fluctuations remained within 0.1 K/h while controlling an overall temperature of 170 K with a temperature difference of +/- 5 K. Changes in the electrical input power of cryocooler had no influence on the temperature distribution. This advancement not only lowers the operating temperature of the optical cavity to minimize spectral interference but also enhances the precision and efficiency of temperature control.

Modeling and Analysis of Thermal Cycle System for Quantitative PCR Instrument

Research on thermal cycle system for real-time PCR instrument based on equivalent circuit model

FEA for Steady-State Thermal Performance of PCR Thermal-Cycler Based on Thermoelectric Cooler

Study on factors affecting thermal performance of PCR thermal cycle system by equivalent circuit

Research and verification of thermal model for PCR instrument temperature field

FEA simulation research of temperature uniformity in quantitive PCR thermal cycle system

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

Electromagnetic-Circuital-Thermal Co-Simulation for Integrated Circuits and Microwave Applications

A Simplification Method for Power Device Thermal Modeling with Quantitative Error Analysis

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Thermal Analysis of Power MMICs Based on Computerization.

Electrical-thermal Co-Analysis of Through Silicon Via with Equivalent Circuit Model

A Thermal Cycler Based on Magnetic Induction Heating and Anti-Freezing Water Cooling for Rapid PCR

Analytical Model of Thermal Field in Polymer Thermo-Optic Devices

Numerical Simulation and Experimental Verification of Dynamic Cooling and Temperature Control of the Optical Cavity in a Co2 Isotope Analyzer

A Thermal Cycler based on Solid-state Active Heat Pump and PID Control Algorithm toward Biomedical Applications

Modelling and analysis of a liquid-cooled system for thermal management application of an electronic equipment

Numerical Simulation of Micro Flow-Through Pcr Chip

A Model for the Non-steady-state Temperature Behavior of Semiconductor Cooling System and its Experimental Analysis

Analysis Of Thermal Cycling In Micro-Pcr Chip