Abstract:The short operating life of metallic diaphragm caused by fracture is one of the main disadvantages for diaphragm compressors used in hydrogen fueling stations. A new generatrix for cavity profile is proposed through optimization using the complex method to decrease the maximal radial stresses on both oil and gas sides of the diaphragm clinging to the cavity surface. In the optimization, the convex part of the cavity generatrix is subjected to a constraint that the generatrix has a lower slope than the deformed diaphragm under a uniform pressure load. This constraint aims to avoid cavity dead volume at the end of the gas discharge process. Thus, an analytical solution for the deflection of an edge-clamped metallic diaphragm under a uniform pressure load is firstly developed. The solution employs the principle of minimum energy and the Rayleigh-Ritz method, which based on the theory of thin plates with large deflections. Experimental measurements, as well as the finite elements method (FEM), are employed to validate the solution. The analytical results are found to be in good agreement with the results of measurements and FEM simulations. Secondly, the stress of the diaphragm with a specific deflection is calculated, and the radial stress concerning both gas side and oil side of the diaphragm is taken as the objective function. Finally, a new generatrix is obtained through the optimization. The radial stress of the diaphragm clinging to the new cavity profile is validated via the FEM simulation, and results match well with each other. It also approves that the cavity dead volume is eliminated by the new generatrix at the end of the gas discharge process. Moreover, the maximal and the centric radial stress of the working diaphragm were compared between the new generatrix and the traditional generatrix under the same design parameters, the maximal and the centric radial stress of the diaphragm decreased by 8.2% and 13.9%, respectively. Based on the proposed design method, effects of the cavity volume, cavity radius, diaphragm thickness and diaphragm material properties on the maximal radial stress of the working diaphragm are further discussed.

Analysis and Study on the Diaphragm Cavity Profile of Diaphragm Compressors

Mechanical Deformation Analysis of Diaphragm Compressor Metal Diaphragm

Design and Validation of New Cavity Profiles for Diaphragm Stress Reduction in a Diaphragm Compressor

FEA of Diaphragm in Diaphragm Compressor Based on ABAQUS

Optimization Design of Diaphragm Compressor Cavity Contour with New Generatrix

A new generatrix of the cavity profile of a diaphragm compressor

Study on Flow Field in Capacity Regulating Actuator for Reciprocating Compressor

Multi-objective optimization of membrane cavity curve of diaphragm compressor and its verification

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

A New Cavity Profile for a Diaphragm Compressor Used in Hydrogen Fueling Stations

The cavity profile of a diaphragm compressor for a hydrogen refueling station

Asymmetric Deformation of Near Hemispherical Diaphragm under Uniform Surface Load

Study on the Stress and Deformation of a Diaphragm Compressor Cylinder Head under Extreme Conditions

The Finite Element Analysis of the Deflection of the Crankshaft of Rotary Compressor

FEM Analysis on the Deformation of Bearing Faces of Rotary Compressor

Finite Element Analysis on the Diaphragm Spring’s Load-Deformation Characteristic of DCT

Study on the diaphragm fracture in a diaphragm compressor for a hydrogen refueling station

The Analysis of Plastic Deformation for the Turbine Diaphragm

Numerical Analysis Of A Composite Diaphragm Microactuator

A Temperature-Dependent Hyperelastic Constitutive Model for Diaphragm

Analysis of the Performance of the Compressor