Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Residual Stress Analysis and Structural Parameters Optimization of Corrugated Diaphragms Applied to MEMs Device

Research On High-Frequency Vibratory Stress Relief For Small Assembly

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Design and Simulation of Corrugated Diaphragm Applied to the MEMS Fiber Optic Pressure Sensor

Design, Simulation And Evaluation Of Novel Corrugated Diaphragms Based On Backside Sacrificial Layer Etching Technique

Mechanical Modeling of Mesa-Diaphragm Structures in Microelectromechanical Systems

Demolding Defects and the Design of Demolding Device in Micro Hot Embossing Process

Evaluation of Die Stress in MEMS Packaging: Experimental and Theoretical Approaches

Design, Simulation and Optimization of a Highly Sensitive Micromachined Membrane

An Incremental Theory for Response Analysis of Mems Diaphragm with Initial Stress

Design, Test and Evaluation of a Novel Die-Attach Structure for Packaging Stress Suppression of MEMS Resonant Accelerometers

Analysis of Residual Stresses in Curved Cutouts of Steel Box Girder Transverse Diaphragms

Study of Residual Stress Compensation in Continuous Membrane Micromirrors Based on Surface Micromachining Processes

Analytical Deflection Model and Parametric Optimization of a Circular Diaphragm-type Piezoactuator

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses

Finite element analysis of residual stresses and thin plate distortion after face milling

Analysis and Measurement of Residual Stress in Bridge Membrane MEMS Relays

Evaluation of Residual Stress in MEMS Micromirror Die Surface Mounting Process and Shock Destructive Reliability Test