Abstract:Injection molding of microfluidic chips and minimization of demolding force. The demolding process in micro‐injection molding constitutes a critical phase, exerting a decisive influence on the quality of polymer microstructures. In this study, the demolding forces of PMMA microfluidic chips were measured under different demolding temperatures, packing pressures, and demolding speeds by using pure nickel (Ni) mold insert. The dimensional deviations of the microchannels with different aspect ratios were analyzed. In addition, the effect of mold insert modification on the demolding force was further analyzed. The results showed that the effect of demolding temperature on the demolding force was the most significant, and the peak demolding force decreased with the decrease in temperature. The width of the microchannels increased and the depth decreased after demolding, while the opposite results were observed for the micro‐mixing structures. However, the dimensional deviation of the micro‐mixing structures was larger than that of the microchannels. Using the optimal molding parameters, the peak demolding force could be reduced from 114.0 N at 110°C to 47.0 N, a decrease of 58.8%. It is noteworthy that, when the microchannel was narrower than 100 μm, achieving precise replication of microchannel dimensions became progressively more challenging as the microchannel width decreased. Using the Ni‐WS2 mold insert with low surface energy and low friction coefficient, the demolding force could be further reduced by 38.3%. The effect of the molding quality of microfluidic chip microstructures on the mixing performance of heavy metals was demonstrated by micro‐mixing experiments. Highlights Demolding temperature crucially affects microstructure dimensions. Optimal parameters and modified mold insert reduce demolding force by 38.3%. Dimensional deviation increases with the increase of microchannel aspect ratio. Optimized microfluidic chip enhances Co2+ chemiluminescence by 6.42%.

Demolding Defects and the Design of Demolding Device in Micro Hot Embossing Process

Defects in Micro Hot Embossing Process

Research on Optimization of the Hot Embossing Process

Optimization of Control Parameters in Micro Hot Embossing

Study on Polymer Flow Profile in Micro Hot Embossing

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Simulation Research on Stress of Polymeric Patterns During Micro Hot Embossing

Flow Behavior of Polymer During Micro Hot Embossing

Effect of Interfacial Interaction on the Demolding Deformation of Injection Molded Microfluidic Chips

Enhanced Polymer Filling and Uniform Shrinkage of Polymer and Mold in A Hot Embossing Process

Studies of Polymer Deformation and Recovery in Hot Embossing

Research on Modeling of Hot Embossing Polymeric Microfluidic Chip

Micro/nanofabrication of Brittle Hydrogels Using 3D Printed Soft Ultrafine Fiber Molds for Damage-Free Demolding.

Interaction of Multiple Micro-Defects on the Strength and Failure Mechanism of UD Composites by Computational Micromechanics

Enhancing structural replication of microfluidic chips: Parameter optimization and mold insert modification

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Experimental Study on the Hot Embossing Polymer Microfluidic Chip

Experimental Study on the Fabrication of the Light Guide Plate with Hot Embossing Method

A Spring-Driven Press Device For Hot Embossing And Thermal Bonding Of Pmma Microfluidic Chips

Impact of process parameters on the flow behavior and filling accuracy of photoresist in hot embossing for microgroove array

In-situ observation on the real-time filling deformation of PMMA into microchannel during hot embossing