Abstract:Mild steel is a kind of material commonly used in the chemical industry and to manufacture machinery, farm tools, and other parts in order to improve the surface performance of the parts and prolong their service life. The Ni-TiN composite coating was fabricated through ultrasonic electroplating using a Ni-based sulfamic acid bath with added nano-TiN particles. The effects of three distinct current modes, direct current (DC), positive pulse current (PC), and positive–negative pulse current (PNPC), on various aspects of the coating, including surface morphology, TiN content and distribution, interface bonding strength, microhardness, friction and wear properties, as well as corrosion resistance, were investigated. The findings demonstrated that, in comparison to DC electroplating, PC electrodeposited Ni-TiN composite coatings yielded finer grains, smoother surfaces, reduced surface cracks, increased interface bonding strength, and enhanced corrosion resistance. Furthermore, PNPC electrodeposited Ni-TiN composite coatings showed higher interface bonding strength than those of PC electrodeposited Ni-TiN coatings and had the densest structure, leading to the best corrosion resistance. Pulse current electroplating enhanced the incorporation of nano-TiN particles, with a higher deposition rate observed in positive–negative pulse current electroplating compared to positive pulse current electroplating. Furthermore, the PNPC electrodeposited coating displayed improved microhardness and demonstrated the best friction and wear properties, while the DC electroplated coating displayed the least favorable performance in these aspects.

Preparation Of Foamed Nickel By Pulse Electrodeposited

Optimization of Preparation Parameters for Pulse Jet Electrodepositing Nanocrystal Nickel Coatings

Preparation and corresponding structure of nickel foam

Preparation of Electrodeposited Foam Fe-Ni Alloy Coating with Low Content of Nickel

Surface morphology and crystal orientation of electrodeposited tungsten coatings with different pulse parameters

Process for Nickel-Phosphorous Pulse Electroplating and Corrosion Resistance of the Alloy Coating

Relationship Between Tensile Strength and Preparation Conditions for Nickel Foam

Preparation and Investigation of Ni–Co–P Alloy Coatings Using Jet Electrodeposition with Varying Pulse Parameters

Preparation of thin solid CoNiFe films by pulse-reverse electroplating technique

Effect of the Pulse Duty Cycle on the Microstructure and Properties of a Jet Electrodeposited Nanocrystalline Copper Coating

RESEARCH ON PREPARATION OF NICKEL POWDER BY ELECTROLYTIC DEOXIDATION FROM NiO

Optimisation of parameters of complete nickel electrodeposition from acidic aqueous electrolytic baths prepared by dissolution of metal powder

Effect of Preparation Condition on Electrochemical Property of Nano-Nickel Powders

Preparation of Hollow Nickel Fibres by Electroless-Plating Technique

Froth Floatation Integrated into Electrodeposition to Prepare Ni/Short Carbon Fibers Composites with Network and Sheet Structures

Effect of Pulse Electrodeposition Mode on Microstructures and Properties of Ni-TiN Composite Coatings

Preparation and Microstructure of Nanocrystalline Fe-Ni-Mo Alloy with Low Mo and High Fe Content

Cobalt Electroplating on Nickel Foam to Improve Performance of Nickel Positive Electrode

Electrochemical Performances of Nanostructured Ni3P–Ni Films Electrodeposited on Nickel Foam Substrate

Microstructure and Corrosion Behavior of Electrodeposited Nickel Prepared from a Sulphamate Bath

Influence of Average Current Density and Pulse Frequency on Morphology and Structure of Pulse-reverse Current Electroplated Ni Plating