Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Experimental Research on the Thermo-dynamic Coupling Behavior on Contact Surface Friction

Influence of Different Sliding Velocity on the Thermo-Mechanical Coupling of the Rough Surface Contact

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Influence of Different External Pressure on the Thermo-Mechanical Coupling of the Rough Surface during Sliding Contact

Effect of surface roughness on sliding friction in lubricated contacts-reciprocal experiment study

Study on Frictional Heating of Rough Surface in the Sliding Process

Study on the Influence of Temperature on Interfacial Micro-Friction

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

Investigation on Adhesion Work and Its Effects on Micro Friction

Experimental Investigation of the Contact Mechanism of Solid Surfaces with a Surface Force Apparatus

Experimental study on ultrasonic antifriction behavior

"SLIDING FRICTION BETWEEN AMORPHOUS COTTON FIBER AND CHROMIUM SURFACES: A MOLECULAR DYNAMICS STUDY "

Calculating Frictional Force with Considering Material Microstructure and Potential on Contact Surfaces

Experimental Study and Simulation Analysis on Friction Behavior of A Mechanical Surface Sliding on Hard Particles

The Influence of Sliding Speed on the Friction Behavior of Silica Surface

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Friction properties of the single-crystal Si in collision sliding contacts under different lubrication conditions

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Tribological mechanism of micro/meso/macroscopic textured surfaces under different normal forces, relative velocities, and sliding directions

Experimental Study of Air Squeeze Effect on High-Frequency Friction Contact

Experimental Study on Friction Damping Characteristics of Metallic Materials with Non-Conforming Contact