Abstract:Annealing Mg-implanted homoepitaxial GaN at temperatures above 1400 °C eliminates the formation of inversion domains and leads to improved dopant activation efficiency. Extended defects, in the form of inversion domains, contain electrically inactive Mg after post-implantation annealing at temperatures as high as 1300 °C (one GPa N2 overpressure), which results in a low dopant activation efficiency. Triple-axis x-ray data reveal that implant-induced strain is fully relieved after annealing at 1300 °C for 10 min, indicating that strain-inducing point defects formed during implantation have reconfigured and inversion domains are formed. However, annealing at temperatures of 1400–1500 °C (one GPa N2 overpressure) eliminates the presence of the inversion domains. While residual defects, such as dislocation loops, still exist after annealing at and above 1400 °C, chemical analysis at multiple dislocation loops shows no sign of Mg segregation. Meanwhile, an overall decreasing trend in the dislocation loop density is observed after annealing at the higher temperatures and longer times. Additionally, once inversion domains are formed and the samples are cooled to room temperature, they are shown to dissolve with subsequent annealing above 1400 °C. While such defects have been observed before, the important finding that such defects can be dissolved with a short, higher temperature step is key. Earlier work [Breckenridge et al., J. Appl. Phys. Lett. 118, 022101 (2021)] addressing electrical measurements of these types of samples showed that annealing at 1400 °C leads to a dopant activation efficiency that is an order of magnitude higher than that observed at 1300 °C. This work complements earlier work by identifying the inversion domains, which incorporate Mg, and points to the benefits, in terms of defect density and p-type dopant activation, of using higher temperature (>1400 °C) annealing cycles to activate Mg in GaN, even if the Mg-containing inversion domains had been formed during lower temperature annealing.

Defect Evolution in Annealed P-Type GaAsN Epilayers Grown by Metalorganic Chemical Vapour Deposition

Influence of Isochronal Annealing on the Evolution of Hole Traps in GaAsN Epilayers Grown by Metalorganic Chemical Vapor Deposition

Defects in GaN Films Studied by Positron Annihilation Spectroscopy

Evolution of Interface Chemistry and Dielectric Properties of Hfo2/Ge Gate Stack Modulated by Gd Incorporation and Thermal Annealing

Evolution Of Traps In Tin/O-3-Sourced Al2o3/Gan Gate Structures With Thermal Annealing Temperature

The Origin and Evolution of V-defects in InxAl1−xN Epilayers Grown by Metalorganic Chemical Vapor Deposition

Study of Low-Frequency Excess Noise in Rta Annealed N-Type Gallium Nitride

Dissolution of Mg-enriched defects in implanted GaN and increased p-type dopant activation

P-Type Gan Directly Grown by Low Pressure Metalorganic Vapor Phase Epitaxy

Growth and Annealing Study of Mg-Doped AlGaN and GaN/AlGaN Superlattices

Thermal Annealing Effect on Low-Temperature Molecular-Beam Epitaxy-Grown Gaas - Arsenic Precipitation and the Change of Resistivity

Research on Evolution of Relevant Defects in Heavily Mg-Doped GaN by H Ion Implantation Followed by Thermal Annealing

Effect of High Temperature, High Pressure Annealing on GaN Drift Layers for Vertical Power Devices

Transport Properties of Gaas Layers Grown by Molecular Beam Epitaxy at Low Temperature and the Effects of Annealing

Deep-Level Defects Induced Degradation of Negative Differential Resistance in GaN-Based Resonant Tunneling Diodes

Deep levels in MOCVD Al0.48In0.52As/InP

Effect of Rapid Thermal Annealing on Behavior of Nitrogen in GaAsN Alloys

Strain Enhancement During Annealing of Gaasn Alloys

Deep Level Investigation of INGAAS on INP Layer

Non-Equilibrium Acceptor Concentration in Gan : Mg Grown by Metalorganic Chemical Vapor Deposition

Defect Reduction in Gan Epilayers Grown by Metal-Organic Chemical Vapor Deposition with in Situ Sinx Nanonetwork