Abstract:Miniaturization of the medical implants is a key requirement for minimally-invasive surgery, while battery and antenna are the main bottlenecks. Wireless power transfer (WPT) is required to minimize or eliminate the battery, but the conventional inductive or capacitive WPT needs to implant a large inductor or capacitor to realize a relatively high efficiency. Based on the WPT, backscattering communication is widely used in medical implants due to its low power and low hardware cost. In conventional backscattering, the inductive or capacitive antenna of the implant should be large to improve the signal-to-noise ratio (SNR). In this work, we propose a new current-switching technique for the communication of medical implants. To avoid the use of antennas, the body tissue is utilized as the power-transfer medium, where a current loop is formed between the implanted and the external electrode pairs. The data of the medical implant controls its input impedance, and then switches the current loop, resulting in a data-modulated current in the external device. In this way, the external device can sense the data, achieving a high communication SNR without implanted antenna. A prototype is implemented to validate the proposed technique, where the implanted electrodes are as small as 200µ×200µm. Operating at 406 MHz of the standard medical band, the measurement shows that the signal-to-blocker ratio (SBR) achieves -35.7 dB, resulting in a high communication SNR of 21.9 dB at a data rate of 10 Mbps.

Wireless Switch for Implantable Medical Devices Based on Passive RF Receiver

A Current-Switching Communication Technique for Miniaturized Medical Implants

Optimal Design of a Low-Power, Phase-Switching Modulator for Implantable Medical Applications.

A new wireless actuator integrating magnetic resonance coupling with reluctance actuator

Developing Innovation — Wireless Transceiver Design for Implantable Medical Devices

A 6.78 MHz Maximum Efficiency Tracking Active Rectifier with Load Modulation Control for Wireless Power Transfer to Implantable Medical Devices

A 13.56MHz Wireless Power Transfer System with Dual-Output Regulated Active Rectifier for Implantable Medical Devices

Wireless energy and signal transmission system for micro implantable medical system

An omnidirectional wireless power receiving IC with 93.6% efficiency CMOS rectifier and Skipping Booster for implantable bio-microsystems

A Battery-Less Crystal-Less 49.8µw Neural-Recording Chip Featuring Two-Tone RF Power Harvesting.

Single-Switch-Regulated Resonant WPT Receiver

A 6.78 MHz High-Efficiency Wireless Power Transfer Transmitter With Adaptive Dead-Time Control and Transistor-Width Switching for Implantable Medical Devices

An area efficient inductorless super-regenerative receiver front-end for biomedical implant devices

Electro-thermally actuated RF MEMS switch for wireless communication.

A Passive RF Receiving and Power Switch ASIC for Remote Power Control with Zero Stand-by Power

A Bioresorbable Magnetically Coupled System for Low‐Frequency Wireless Power Transfer

Distance and Load Insensitive Inductive Powering for Implantable Medical Devices Through Wireless Communication

Study of a Transcutaneous Wireless Communication System

A resonant current-mode wireless power transfer for implantable medical devices: an overview

Simplified Reconfigurable Rectifier with Consistent Input Capacitance for Wireless Power Transfer

A High-Efficiency, Low-Power Wireless Power and Data Frontend for Implantable Applications