Abstract:In this article, an active rectifier with pulse width modulation (PWM) mode on- and off-delay compensation technique is proposed. Conventional delay compensation modes: current mode, voltage mode, and delay-based mode are discussed respectively. Also, the adaptive delay compensation technique and potential disturbance problems are analyzed. To achieve wide and flexible delay compensation range, the proposed rectifier adopts current mode delay compensation methods to eliminate on- and off-delay. Moreover, PWM mode feedback loops are built to compensate circuit delays adaptively under various process, voltage, and temperature (PVT) and loading conditions. Compared with previous works, the proposed PWM mode technique converts the fluctuant error voltages into the fixed duty cycle signal in each cycle, avoiding the disturbance on compensation current and even error flips of comparators. The stability of the current compensation is improved. The proposed active rectifier was designed and fabricated in CMOS process. Both TX and RX coils are designed and fabricated on printed circuit board (PCB), and the diameter is limited below 3cm. Measurement results show that, with the input sine voltage amplitude ranging from 1.5V to 2.4V and 2MHz operating frequency, the peak power conversion efficiency (PCE) achieves 91.7% under loading resistor and the peak voltage conversion ratio (VCR) achieves 93.7% with loading resistor. The maximum output power reaches 57.6 mW. Compared with the case with no PWM mode delay compensation, the measurement PCE and VCR are improved by at least 9%. The proposed rectifier achieves better dynamic performance and is suitable for wireless power transfer (WPT).

A 13.56MHz Wireless Power Transfer System with Dual-Output Regulated Active Rectifier for Implantable Medical Devices

A 13.56 MHz pulse-width modulation active rectifier for implantable medical devices

A 6.78 MHz Maximum Efficiency Tracking Active Rectifier with Load Modulation Control for Wireless Power Transfer to Implantable Medical Devices

A 13.56 MHz Efficient Active Rectifier with Quasi-Constant Delay Compensation Scheme for Implantable Medical Devices.

Optimal Design of a Low-Power, Phase-Switching Modulator for Implantable Medical Applications.

A 13.56 MHz Active Rectifier with Self-Switching Comparator for Wireless Power Transfer Systems

2-20-V Wide Input Range Active Rectifier with Single-Multiplexing Adaptive Delay Compensation and Low-Voltage Enhancement for Wireless Power Transmission

A High-Efficiency, Low-Power Wireless Power and Data Frontend for Implantable Applications

A 6.78 MHz, 95.0% Peak Efficiency Monolithic Two-Dimensional Calibrated Active Rectifier for Wirelessly Powered Implantable Biomedical Devices

Reconfigurable Resonant Regulating Rectifier With Primary Equalization for Extended Coupling- and Loading-Range in Bio-Implant Wireless Power Transfer

A 6.78 MHz High-Efficiency Wireless Power Transfer Transmitter With Adaptive Dead-Time Control and Transistor-Width Switching for Implantable Medical Devices

A Wireless Charging Circuit with High Power Efficiency and Security for Implantable Devices

Enhancement Method of Efficiency and Working Range in Bio-Implant Wireless Power Transfer

An omnidirectional wireless power receiving IC with 93.6% efficiency CMOS rectifier and Skipping Booster for implantable bio-microsystems

A Current-Switching Communication Technique for Miniaturized Medical Implants

A Wireless Power and Data Transfer Receiver Achieving 75.4% Effective Power Conversion Efficiency and Supporting 0.1% Modulation Depth for ASK Demodulation

A resonant current-mode wireless power transfer for implantable medical devices: an overview

A High-Efficiency 40.68-MHz Single-Stage Dual-Output Regulating Rectifier With ZVS and Synchronous PFM Control for Wireless Powering

Dual-Band Rectifier Design With High Efficiency Using Simple Dual Band-Stop Network for Wireless Power Transfer

A VHF Wide-Input Range CMOS Passive Rectifier With Active Bias Tuning

An Active Rectifier With Pulse Width Modulation (PWM) Mode On- and Off-Delay Compensation for Wireless Power Transfer (WPT) System