Abstract:For a magnetic coupling resonant wireless power transfer (MCR-WPT) system, the most challenging design issue is to maintain the reasonable transfer efficiency and the output power, especially over varying transmitting distances. To address this issue, this study proposes an adaptive impedance matching (AIM) system with a fast optimization control algorithm for the MCR-WPT system. By dynamically monitoring system input impedance variations at a given frequency, the matching system can be automatically activated. The matching precision is enabled by combining an amplitude-phase measurement circuit, a Pi-type impedance matching (IM) network, and the local optimization algorithm. Experimental comparisons show a significant improvement in the transfer efficiency. The maximum improvement is over 32.6%. The results also show that the local optimization algorithm helps the MCR-WPT system to effectively overcome the efficiency challenges caused by parasitic parameters, resulting in a maximum improvement of 19.8%. The stability of the output power is also significantly improved, with a 27.8% reduction in oscillation amplitude compared to the scenario without the local optimization algorithm, and a 60.0% reduction compared to the scenario without the IM network. The output power range (1.55 - 2.21 W) could meet the power requirements of most implantable medical devices. Moreover, this system adopts a control algorithm of tracking the theoretically optimal matching solution through Microcontroller Unit (MCU) computation, leading to a notable enhancement in matching accuracy.

Enhancement Method of Efficiency and Working Range in Bio-Implant Wireless Power Transfer

Reconfigurable Resonant Regulating Rectifier With Primary Equalization for Extended Coupling- and Loading-Range in Bio-Implant Wireless Power Transfer

A 6.78 MHz Maximum Efficiency Tracking Active Rectifier with Load Modulation Control for Wireless Power Transfer to Implantable Medical Devices

A Current-Switching Communication Technique for Miniaturized Medical Implants

Simulative and Experimental Research on Wireless Power Transmission Technique in Implantable Medical Device

A Wireless Power-Efficient Charger Chip with Closed-Loop Controlling Mechanism for Implantable Biomedical System

An omnidirectional wireless power receiving IC with 93.6% efficiency CMOS rectifier and Skipping Booster for implantable bio-microsystems

A 13.56MHz Wireless Power Transfer System with Dual-Output Regulated Active Rectifier for Implantable Medical Devices

Wireless Power Transfer Techniques for Implantable Medical Devices: A Review

Wireless Power Transmission Efficiency Improved by Conformal Phase Gradient Metasurface for Implanted Devices

A Linear-Power-Regulated Wireless Power Transfer Method for Decreasing the Heat Dissipation of Fully Implantable Microsystems

Developing Innovation — Wireless Transceiver Design for Implantable Medical Devices

2-20-V Wide Input Range Active Rectifier with Single-Multiplexing Adaptive Delay Compensation and Low-Voltage Enhancement for Wireless Power Transmission

Wireless Power Delivery Techniques for Miniature Implantable Bioelectronics

A Wireless Charging Circuit with High Power Efficiency and Security for Implantable Devices

A resonant current-mode wireless power transfer for implantable medical devices: an overview

A 6.78 MHz High-Efficiency Wireless Power Transfer Transmitter With Adaptive Dead-Time Control and Transistor-Width Switching for Implantable Medical Devices

Distance and Load Insensitive Inductive Powering for Implantable Medical Devices Through Wireless Communication

Wireless Power Transfer for Implanted Medical Application: A Review

Simplified Reconfigurable Rectifier with Consistent Input Capacitance for Wireless Power Transfer

An Adaptive Impedance Matching System With Fast Optimization Control Algorithm for Wireless Power Transfer via Magnetic Coupling Resonance