Abstract:Inductively coupled coil pair is the most common way of wirelessly transferring power to medical implants. However, the coil displacements and/or loading changes may induce large fluctuations in transmitted power into the implant if no adaptive control is used. In such cases, it is required to transmit excessive power to accommodate all the working conditions, which substantially reduces the power efficiency and imposes potential safety concerns. We have implemented a power transfer system with adaptive control technique to eliminate the power variations due to the loading or coupling coefficient changes. A maximum of 250 mW power is transmitted through an optimized coil pair driven by Class-E power amplifier. Load shift keying is implemented to wirelessly transfer data back from the secondary to primary side over the same coil pair, with data rate of 3.3 kbps and packet error rate less than 10(-5). A pseudo pulsewidth modulation has been designed to facilitate back data transmission along with forward power transmission. Through this back telemetry the system transmits the information on received power, back from implant to primary side. According to the data received, the system adjusts the supply voltage of the Class-E power amplifier through a digitally controlled dc-dc converter, thus varying the power sent to the implant. The key system parameters are optimized to ensure the stability of the closed-loop system. Measurements show that the system can transmit the 'just-needed' power for a wide range of coil separation and/or loading conditions, with power efficiency doubled when compared to the uncompensated link.

Distance and Load Insensitive Inductive Powering for Implantable Medical Devices Through Wireless Communication

An Inductive Power Transfer System With Adjustable Compensation Network For Implantable Medical Devices

A Current-Switching Communication Technique for Miniaturized Medical Implants

Design and Analysis of an Adaptive Transcutaneous Power Telemetry for Biomedical Implants

A Closed Loop Transcutaneous Power Transfer System For Implantable Devices With Enhanced Stability

Simulative and Experimental Research on Wireless Power Transmission Technique in Implantable Medical Device

A Study of Wireless Power Transfer for Implantable Devices by Using Wearable Devices

Wireless Power Transmission Equipment Used For Implantable Cardiac Pacemakers

Wireless Power Transfer Techniques for Implantable Medical Devices: A Review

Enhancement Method of Efficiency and Working Range in Bio-Implant Wireless Power Transfer

Efficient Wireless Power Transfer for Biomedical Implant Application

Optimization of the Coupling Coefficient of the Inductive Link for Wireless Power Transfer to Biomedical Implants

A Linear-Power-Regulated Wireless Power Transfer Method for Decreasing the Heat Dissipation of Fully Implantable Microsystems

Towards Flexible Wireless Charging for Medical Implants Using Distributed Antenna System

A 6.78 MHz Maximum Efficiency Tracking Active Rectifier with Load Modulation Control for Wireless Power Transfer to Implantable Medical Devices

A Novel Design of Transcutaneous Power and Data Bidirectional Transfer System for Biomedical Implants

An ultrasound-driven implantable wireless energy harvesting system using a triboelectric transducer

Power Transferring and Analogue Communication Approach for Implantable Devices.

Implantable Wireless Power Receiver with Self-Displayed Power Meter

Design and Implementation of a Hybrid Wireless Power and Communication System for Medical Implants

Electronic Design for an Implantable Wireless Power and Data Transmission System